UPD70F3786GJ-GAE-AX Renesas Electronics America, UPD70F3786GJ-GAE-AX Datasheet - Page 1681

• Manufacturer Part Number: UPD70F3786GJ-GAE-AX
• Description: MCU 32BIT V850ES/JX3-E 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Er

Specifications of UPD70F3786GJ-GAE-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: CAN, CSI, EBI/EMI, Ethernet, I²C, UART/USART, USB
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 100
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 124K x 8
• Voltage - Supply (vcc/vdd): 2.85 V ~ 3.6 V
• Data Converters: A/D 12x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(4) RESET pin
(5) Port pins (including NMI)
(6) Other signal pins
(7) Power supply
When the reset signals of the dedicated flash programmer are connected to the RESET pin that is connected
to the reset signal generator on-board, a conflict of signals occurs. To avoid the conflict of signals, isolate the
connection to the reset signal generator.
When a reset signal is input from the user system in the flash memory programming mode, the programming
operation will not be performed correctly. Therefore, do not input signals other than the reset signals from the
dedicated flash programmer.
When the system shifts to the flash memory programming mode, all the pins that are not used for flash
memory programming are in the same status as that immediately after reset. If the external device connected
to each port does not recognize the status of the port immediately after reset, pins require appropriate
processing, such as connecting to V
Connect X1, X2, XT1, XT2, and REGC in the same status as that in the normal operation mode.
During flash memory programming, input a low level to the DRST pin or leave it open. Do not input a high
level.
Supply the same power (V
V850ES/JH3-E,
V850ES/JJ3-E
RESET
In the flash memory programming mode, the signal that the reset signal generator
outputs conflicts with the signal that the dedicated flash programmer outputs.
Therefore, isolate the signals on the reset signal generator side.
DD
Figure 33-15. Conflict of Signals (RESET Pin)
Conflict of signals
, V
SS
, EV
CHAPTER 33 FLASH MEMORY
DD
DD
via a resistor or connecting to V
User’s Manual U19601EJ2V0UD
, UV
DD
, AV
Reset signal generator
Dedicated flash programmer
connection pin
REF0
Output pin
, AV
SS
) as in normal operation mode.
SS
via a resistor.
1679