S1D13705 Epson Electronics America, Inc., S1D13705 Datasheet - Page 235

• Manufacturer Part Number: S1D13705
• Description: S1d13705 Embedded Memory Lcd Controller
• Manufacturer: Epson Electronics America, Inc.

Epson Research and Development
Vancouver Design Center
Program Messages
13705PWR Power Save Utility
Issue Date: 01/02/12
ERROR: Did not find a 13705 device.
The HAL was unable to read the revision code register on the S1D13705. Ensure that the S1D13705
hardware is installed and that the hardware platform has been configured correctly. Also check that
the display memory address has been configured correctly.
ERROR: Unable to locate/load S1D13XXX.VXD
13705PLAY was unable to load a required driver. The file S1D13XXX.VXD should be located in
x:\WINDOWS\SYSTEM or in x:\WINNT\SYSTEM. If the file is not there, install it as described in
the S1D13XXX 32-Bit Windows Device Driver Installation Guide, document number X00A-E-003-
xx.
ERROR: An IOCTL error occurred
This message indicates an error at the IO control layer occurred. The usual cause for this is an
incorrect hardware configuration.
ERROR: The HAL returned an unknown error
This message should never be displayed, it indicates that 13705SHOW is unable to determine the
cause of an error returned from the HAL.
Software Power Save Mode set.
This message is a confirmation that the register setting to enable software power save mode has been
set.
Software Power Save Mode reset.
This message is a confirmation that the register setting to disable software power save mode has been
set.
Hardware Power Save Mode is now Enabled.
This message confirms that hardware initiated power save mode has been enabled. The S1D13705
will enter a hardware power save mode upon application of the appropriate logic level to the
hardware power save mode input pin.
Hardware Power Save Mode is now Disabled.
This message confirms that the register setting to disable hardware initiated power save mode has
been set. In this state the S1D13705 should ignore the state of the hardware power save mode input
pin.
X27A-B-007-02
S1D13705
Page 5