S1D13705 Epson Electronics America, Inc., S1D13705 Datasheet - Page 284

• Manufacturer Part Number: S1D13705
• Description: S1d13705 Embedded Memory Lcd Controller
• Manufacturer: Epson Electronics America, Inc.

Page 14
6 Technical Description
6.1 Embedded Memory Support
S1D13705
X27A-G-005-03
Note
The S1D13705 contains 80K bytes of embedded, 16-bit, SRAM used for the display buffer
and a 32 byte internal register set.
Since the S1D13705 does not distinguish between memory and register accesses, both the
80K byte display buffer and the 32 byte register set must be memory mapped into the host’s
memory space.
When using the S5U13705B00C board on an ISA bus system, the board can be configured
to map the S1D13705 to one of two memory blocks.
The SRAM start address is determined by a DIP switch setting. See Table 2-1: “Configu-
ration DIP Switch Settings,” on page 8.
1. When switch S1-5 is in the closed position, the S1D13705 is mapped into segments
2. When switch S1-5 is in the open position, the S1D13705 is mapped into the upper
Starting at the SRAM start address, the board design decodes a 128K byte segment accom-
modating both the 80K byte display buffer and the S1D13705 internal register set. The
S1D13705 registers are mapped into the upper 32 bytes of the 128K byte segment (1FFE0h
to 1FFFFh).
When using the S5U13705B00C board on a non-ISA bus system, system or external
decode logic must map the S1D13705 into an appropriate memory space.
Since VGA and VGA compatible video adapters use address 0C8000, these cards can-
not be used while using the S5U13705B00C board at this memory address. A mono-
chrome display adapter, a terminal, or a non-VGA compatible display adapter must be
used.
0C0000h and 0D0000h.
This memory space is in the first 1M byte of ISA bus memory and should be used if
these segments are not taken up by other devices such as network adapters, SCSI
cards, or other peripherals.
megabyte of ISA bus memory, starting address of F00000h. To use this memory on an
ISA bus system, the system BIOS has to be configured to set a memory ‘hole’ starting
at this address. Some systems allow the user to configure the size of this hole and the
starting address of where it begins while others just allow a 1M byte hole at the top of
the 16M byte memory space. This memory hole is configured by entering the system
CMOS Setup Utility. This memory space should be used if segments 0Dh and 0Eh are
being used by other devices or if a VGA display adapter is needed.
S5U13705B00C Rev. 1.0 ISA Bus Evaluation Board User Manual
Epson Research and Development
Vancouver Design Center
Issue Date: 01/02/13