S1D13705 Epson Electronics America, Inc., S1D13705 Datasheet - Page 243

• Manufacturer Part Number: S1D13705
• Description: S1d13705 Embedded Memory Lcd Controller
• Manufacturer: Epson Electronics America, Inc.

Epson Research and Development
Vancouver Design Center
Example Installation
Installation for CEPC Environment
Comments
Windows® CE Display Drivers
Issue Date: 01/02/12
Windows CE v2.0 can be loaded on a PC using a floppy drive or a hard drive. The two
methods are described below:
• Alternatively, in the examples above, you could substitute 4BPP instead of 8BPP.
• On some CEPC systems creating the 1M byte address hole will cause
1. To load CEPC from a floppy drive:
2. To load CEPC from a hard drive:
LOADCEPC.EXE to fail. In this case contact your Sales Representative for a newer
version of LOADCEPC.EXE called LOAD211X.EXE.
a. Create a DOS bootable floppy disk.
b. Edit CONFIG.SYS on the floppy disk to contain the following line only.
c. Edit AUTOEXEC.BAT on the floppy disk to contain the following lines.
d. Copy LOADCEPC.EXE from c:\wince\public\common\oak\bin to the boota-
e. Confirm that NK.BIN is located in c:\wince\release.
f.
a. Copy LOADCEPC.EXE to the root directory of the hard drive.
b. Edit CONFIG.SYS on the hard drive to contain the following line only.
c. Edit AUTOEXEC.BAT on the hard drive to contain the following lines.
d. Confirm that NK.BIN is located in c:\wince\release.
e. Reboot the system from the hard drive.
ble floppy disk.
Reboot the system from the bootable floppy disk.
mode com1:9600,n,8,1
loadcepc /B:9600 /C:1 /D:2 c:\wince\release\nk.bin
device=a:\himem.sys
mode com1:9600,n,8,1
loadcepc /B:9600 /C:1 /D:2 c:\wince\release\nk.bin
device=c:\himem.sys
X27A-E-001-02
S1D13705
Page 7