MC9S12G FREESCALE [Freescale Semiconductor, Inc], MC9S12G Datasheet - Page 496

• Manufacturer Part Number: MC9S12G
• Description: Ignores external trigger. Performs one conversion sequence and stops.
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Freescale’s Scalable Controller Area Network (S12MSCANV3)
1
16.3.2.8
This register contains the interrupt enable bits for the transmit buffer empty interrupt flags.
496
Module Base + 0x0006
Read: Anytime
Write: Anytime when not in initialization mode; write of 1 clears flag, write of 0 is ignored
TXE[2:0]
Field
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.
2-0
Reset:
W
R
Transmitter Buffer Empty — This flag indicates that the associated transmit message buffer is empty, and thus
not scheduled for transmission. The CPU must clear the flag after a message is set up in the transmit buffer and
is due for transmission. The MSCAN sets the flag after the message is sent successfully. The flag is also set by
the MSCAN when the transmission request is successfully aborted due to a pending abort request (see
Section 16.3.2.9, “MSCAN Transmitter Message Abort Request Register
transmit interrupt is pending while this flag is set.
Clearing a TXEx flag also clears the corresponding ABTAKx (see
Message Abort Acknowledge Register
is cleared (see
When listen-mode is active (see
cannot be cleared and no transmission is started.
Read and write accesses to the transmit buffer will be blocked, if the corresponding TXEx bit is cleared
(TXEx = 0) and the buffer is scheduled for transmission.
0 The associated message buffer is full (loaded with a message due for transmission)
1 The associated message buffer is empty (not scheduled)
MSCAN Transmitter Interrupt Enable Register (CANTIER)
The CANTFLG register is held in the reset state when the initialization
mode is active (INITRQ = 1 and INITAK = 1). This register is writable when
not in initialization mode (INITRQ = 0 and INITAK = 0).
0
0
7
Figure 16-10. MSCAN Transmitter Flag Register (CANTFLG)
Section 16.3.2.9, “MSCAN Transmitter Message Abort Request Register
= Unimplemented
Table 16-13. CANTFLG Register Field Descriptions
0
0
6
MC9S12G Family Reference Manual,
Section 16.3.2.2, “MSCAN Control Register 1
0
0
5
(CANTAAK)”). When a TXEx flag is set, the corresponding ABTRQx bit
NOTE
0
0
4
Description
0
0
3
Rev.1.01
Section 16.3.2.10, “MSCAN Transmitter
(CANTARQ)”). If not masked, a
TXE2
2
1
(CANCTL1)”) the TXEx flags
Freescale Semiconductor
Access: User read/write
TXE1
(CANTARQ)”).
1
1
TXE0
0
1
1