MC9S12G FREESCALE [Freescale Semiconductor, Inc], MC9S12G Datasheet - Page 695

• Manufacturer Part Number: MC9S12G
• Description: Ignores external trigger. Performs one conversion sequence and stops.
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Upon clearing CCIF to launch the Erase Flash Block command, the Memory Controller will erase the
selected Flash block and verify that it is erased. The CCIF flag will set after the Erase Flash Block
operation has completed.
21.4.6.9
The Erase P-Flash Sector operation will erase all addresses in a P-Flash sector.
Upon clearing CCIF to launch the Erase P-Flash Sector command, the Memory Controller will erase the
selected Flash sector and then verify that it is erased. The CCIF flag will be set after the Erase P-Flash
Sector operation has completed.
Freescale Semiconductor
1
2
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.
As defined by the memory map for FTMRG32K1.
As found in the memory map for FTMRG32K1.
Register
FSTAT
Erase P-Flash Sector Command
CCOBIX[2:0]
Table 21-46. Erase P-Flash Sector Command FCCOB Requirements
CCOBIX[2:0]
Table 21-44. Erase Flash Block Command FCCOB Requirements
MGSTAT1
MGSTAT0
ACCERR
Error Bit
000
001
FPVIOL
Table 21-45. Erase Flash Block Command Error Handling
000
001
MC9S12G Family Reference Manual, Rev.1.01
Global address [15:0] anywhere within the sector to be erased.
Set if CCOBIX[2:0] != 001 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:16] is supplied
Set if the supplied P-Flash address is not phrase-aligned or if the EEPROM
address is not word-aligned
Set if an area of the selected Flash block is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Refer to
Global address [15:0] in Flash block to be erased
0x0A
2
0x09
Section 21.1.2.1
FCCOB Parameters
FCCOB Parameters
Global address [17:16] to identify
for the P-Flash sector size.
Error Condition
P-Flash block to be erased
Global address [17:16] to
identify Flash block
16 KByte Flash Module (S12FTMRG16K1V1)
1
Table
21-25)
2
695