UPD70F3737GC-UEU-AX Renesas Electronics America, UPD70F3737GC-UEU-AX Datasheet - Page 608

• Manufacturer Part Number: UPD70F3737GC-UEU-AX
• Description: MCU 32BIT V850ES/JX3-L 100-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Lr

Specifications of UPD70F3737GC-UEU-AX

• Package / Case: *
• Voltage - Supply (vcc/vdd): 2.2 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Speed: 20MHz
• Number Of I /o: 84
• Core Processor: RISC
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Program Memory Size: 128KB (128K x 8)
• Data Converters: A/D 12x10b, D/A 2x8b
• Oscillator Type: Internal
• Peripherals: DMA, LVD, PWM, WDT
• Connectivity: CSI, EBI/EMI, I²C, UART/USART
• Core Size: 32-Bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

17.13 Wakeup Function
and extension code have been received.
addresses do not match.
addresses are transmitted due to the possibility that an arbitration loss may change the master device (which has
generated a start condition) to a slave device.
determines whether INTIICn signal is enabled or disabled (n = 0 to 2).
608
Transmitting address transmission
Read/write data after address transmission
Transmitting extension code
Read/write data after extension code transmission
Transmitting data
ACK transfer period after data reception
When restart condition is detected during data transfer
When stop condition is detected during data transfer
When SDA0n pin is low level while attempting to generate
restart condition
When stop condition is detected while attempting to
generate restart condition
When DSA0n pin is low level while attempting to generate
stop condition
When SCL0n pin is low level while attempting to generate
restart condition
Notes 1.
The I
This function makes processing more efficient by preventing unnecessary the INTIICn signal from occurring when
When a start condition is detected, wakeup standby mode is set. This wakeup standby mode is in effect while
However, when a stop condition is detected, the IICCn.SPIEn bit is set regardless of the wakeup function, and this
2
C bus slave function is a function that generates an interrupt request signal (INTIICn) when a local address
2.
Table 17-5. Status During Arbitration and Interrupt Request Signal Generation Timing
When the IICCn.WTIMn bit = 1, an INTIICn signal occurs at the falling edge of the ninth clock. When
the WTIMn bit = 0 and the extension code’s slave address is received, an INTIICn signal occurs at the
falling edge of the eighth clock (n = 0 to 2).
When there is a possibility that arbitration will occur, set the SPIEn bit to 1 for master device operation
(n = 0 to 2).
Status During Arbitration
Preliminary User’s Manual U18953EJ1V0UD
CHAPTER 17 I
At falling edge of eighth or ninth clock following byte transfer
At falling edge of eighth or ninth clock following byte transfer
When stop condition is generated (when IICCn.SPIEn bit = 1)
At falling edge of eighth or ninth clock following byte transfer
When stop condition is generated (when IICCn.SPIEn bit = 1)
2
C BUS
Interrupt Request Generation Timing
Note 1
Note 1
Note 1
Note 2
Note 2