HD64F2676VFC33 Renesas Electronics America, HD64F2676VFC33 Datasheet - Page 252

IC H8S MCU FLASH 256K 144-QFP

HD64F2676VFC33

Manufacturer Part Number
HD64F2676VFC33
Description
IC H8S MCU FLASH 256K 144-QFP
Manufacturer
Renesas Electronics America
Series
H8® H8S/2600r
Datasheets

Specifications of HD64F2676VFC33

Core Processor
H8S/2600
Core Size
16-Bit
Speed
33MHz
Connectivity
IrDA, SCI
Peripherals
DMA, POR, PWM, WDT
Number Of I /o
103
Program Memory Size
256KB (256K x 8)
Program Memory Type
FLASH
Ram Size
8K x 8
Voltage - Supply (vcc/vdd)
3 V ~ 3.6 V
Data Converters
A/D 12x10b; D/A 4x8b
Oscillator Type
Internal
Operating Temperature
-20°C ~ 75°C
Package / Case
144-QFP
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Eeprom Size
-

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HD64F2676VFC33
Manufacturer:
RENESAS
Quantity:
5 530
Part Number:
HD64F2676VFC33
Quantity:
9 520
Part Number:
HD64F2676VFC33
Manufacturer:
Renesas Electronics America
Quantity:
10 000
Part Number:
HD64F2676VFC33V
Manufacturer:
RENESAS
Quantity:
5 530
Part Number:
HD64F2676VFC33V
Manufacturer:
ROHM
Quantity:
750 000
Part Number:
HD64F2676VFC33V
Manufacturer:
RENESAS
Quantity:
120
Part Number:
HD64F2676VFC33V
Manufacturer:
RENESAS/瑞萨
Quantity:
20 000
Section 6 Bus Controller (BSC)
6.7.3
If the ABW2 bit in ABWCR corresponding to an area designated as continuous synchronous
DRAM space is set to 1, area 2 to 5 are designated as 8-bit continuous synchronous DRAM space;
if the bit is cleared to 0, the areas are designated as 16-bit continuous synchronous DRAM space.
In 16-bit continuous synchronous DRAM space, 16-bit configuration synchronous DRAM can be
connected directly.
In 8-bit continuous synchronous DRAM space the upper half of the data bus, D15 to D8, is
enabled, while in 16-bit continuous synchronous DRAM space both the upper and lower halves of
the data bus, D15 to D0, are enabled.
Access sizes and data alignment are the same as for the basic bus interface: see section 6.5.1, Data
Size and Data Alignment.
6.7.4
Table 6.9 shows pins used for the synchronous DRAM interface and their functions. To enable the
synchronous DRAM interface, fix the DCTL pin to 1. Do not vary the DCTL pin during operation.
Since the CS2 to CS4 pins are in the input state after a reset, set DDR to 1 when RAS, CAS, and
WE signals are output. For details, see section 10, I/O Ports. Set the OEE bit of the DRAMCR
register to 1 when the CKE signal is output.
Rev. 3.00 Mar 17, 2006 page 200 of 926
REJ09B0283-0300
Data Bus
Pins Used for Synchronous DRAM Interface

Related parts for HD64F2676VFC33