HD64F2676VFC33 Renesas Electronics America, HD64F2676VFC33 Datasheet - Page 834

• Manufacturer Part Number: HD64F2676VFC33
• Description: IC H8S MCU FLASH 256K 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2676VFC33

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 19 Flash Memory (F-ZTAT Version)
Bit
7
6
5
4
3
2
Rev. 3.00 Mar 17, 2006 page 782 of 926
REJ09B0283-0300
Bit Name
FWE
SWE
ESU
PSU
EV
PV
Initial Value
0/1
0
0
0
0
0
R/W
R
R/W
R/W
R/W
R/W
R/W
Description
Flash Write Enable
Reflects the input level at the FWE pin. It is set to 1
when a high level is input to the FWE pin, and
cleared to 0 when a low level is input. When this bit
is cleared to 0, the flash memory transits to the
hardware protection state.
Note: In the H8S/2678R Group, this bit is
Software Write Enable
When this bit is set to 1, flash memory
programming/erasing is enabled. When this bit is
cleared to 0, other FLMCR1 register bits and all
EBR1 and EBR2 bits cannot be set.
Erase Setup
When this bit is set to 1 while FWE = 1 * and SWE
= 1, the flash memory transits to the erase setup
state. When it is cleared to 0, the erase setup state
is cancelled.
Program Setup
When this bit is set to 1 while FWE = 1 * and SWE
= 1, the flash memory transits to the program setup
state. When it is cleared to 0, the program setup
state is cancelled.
Erase-Verify
When this bit is set to 1 while FWE = 1 * and SWE
= 1, the flash memory transits to erase-verify
mode. When it is cleared to 0, erase-verify mode is
cancelled.
Program-Verify
When this bit is set to 1 while FWE = 1 * and SWE
= 1, the flash memory transits to program-verify
mode. When it is cleared to 0, program-verify
mode is cancelled.
reserved. This bit is always read as 0 in
modes 1 and 2. This bit is always read as 1
in modes 3 to 7. The initial value should not
be changed.