HD64F2676VFC33 Renesas Electronics America, HD64F2676VFC33 Datasheet - Page 711

• Manufacturer Part Number: HD64F2676VFC33
• Description: IC H8S MCU FLASH 256K 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2676VFC33

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

14.6.5
This LSI is not reset internally if TCNT overflows while the RSTE bit is cleared to 0 during
watchdog timer mode operation, but TCNT and TCSR of the WDT are reset.
TCNT, TCSR, and RSTCR cannot be written to while the WDTOVF signal is low. Also note that
a read of the WOVF flag is not recognized during this period. To clear the WOVF flag, therefore,
read TCSR after the WDTOVF signal goes high, then write 0 to the WOVF flag.
14.6.6
If the WDTOVF output signal is input to the RES pin, the chip will not be initialized correctly.
Make sure that the WDTOVF signal is not input logically to the RES pin.
To reset the entire system by means of the WDTOVF signal, use the circuit shown in figure 14.6.
Reset signal to entire system
Internal Reset in Watchdog Timer Mode
System Reset by WDTOVF
Figure 14.6 Circuit for System Reset by WDTOVF
Reset input
WDTOVF Signal
WDTOVF
WDTOVF
WDTOVF Signal (Example)
WDTOVF
WDTOVF
Rev. 3.00 Mar 17, 2006 page 659 of 926
Section 14 Watchdog Timer
WDTOVF
RES
This LSI
REJ09B0283-0300