HD64F2676VFC33 Renesas Electronics America, HD64F2676VFC33 Datasheet - Page 374

• Manufacturer Part Number: HD64F2676VFC33
• Description: IC H8S MCU FLASH 256K 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2676VFC33

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: IrDA, SCI
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 103
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 12x10b; D/A 4x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 7 DMA Controller (DMAC)
DREQ pin sampling is performed every cycle, with the rising edge of the next cycle after the
end of the DMABCR write cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is
possible, the request is held in the DMAC. Then, when activation is initiated in the DMAC, the
request is cleared, and DREQ pin high level sampling for edge detection is started. If DREQ pin
high level sampling has been completed by the time the DMA single cycle ends, acceptance
resumes after the end of the single cycle, DREQ pin low level sampling is performed again, and
this operation is repeated until the transfer ends.
DREQ
DREQ Pin Low Level Activation Timing: Set the DTA bit in DMABCRH to 1 for the channel
DREQ
DREQ
for which the DREQ pin is selected.
Rev. 3.00 Mar 17, 2006 page 322 of 926
REJ09B0283-0300
Figure 7.30 Example of DREQ
Address bus
[1]
[2] [5] The request is cleared at the next bus break, and activation is started in the DMAC.
[3] [6] Start of DMA cycle; DREQ pin high level sampling on the rising edge of
[4] [7] When the DREQ pin high level has been sampled, acceptance is resumed after the single
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
DMA control
Channel
DREQ
DACK
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising edge of ,
and the request is held.
cycle is completed. (As in [1], the DREQ pin low level is sampled on the rising edge of , and
the request is held.)
Idle
[1]
Request
Bus release
DREQ
DREQ
DREQ Pin Falling Edge Activated Single Address Mode Transfer
Minimum of
2 cycles
[2]
[3]
Single
Request clear
Transfer source/
DMA single
period
destination
Acceptance resumes
Idle
[4]
Request
Bus release
Minimum of
2 cycles
[5]
[6]
Single
DMA single
Request clear
Transfer source/
destination
period
Acceptance resumes
starts.
Idle
[7]
Bus release