Z8FMC160100KITG Zilog, Z8FMC160100KITG Datasheet - Page 105

• Manufacturer Part Number: Z8FMC160100KITG
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KITG

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphical User Interface
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4660

PS024613-0910
TRIGGERED ONE-SHOT Mode Timeout Period (s) =
Note:
2. Write to the Timer High and Low Byte registers to set the starting count value.
3. Write to the Timer Reload High and Low Byte registers to set the reload value.
4. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing
5. If using the Timer Output function, configure the associated GPIO port pin for the
6. Write to the Timer Control 1 register to enable the timer. Counting does not start until
The timer period is calculated by the following equation (Start Value = 1):
The one-shot delay from input trigger to output includes the above-defined timeout period,
plus an additional delay of 2–3 system clock cycles, due to the synchronization of the input
trigger.
CONTINUOUS Mode
In CONTINUOUS mode, the timer counts up to the 16-bit reload value stored in the Timer
Reload High and Low Byte registers. After reaching the reload value, the timer generates
an interrupt, the count value in the Timer High and Low Byte registers is reset to
and counting resumes. Also, if the Timer Output alternate function is enabled, the Timer
Output pin changes state (from Low to High or High to Low) after timer reload.
Follow the steps below to configure a timer for CONTINUOUS mode and initiate the
count:
1. Write to the Timer Control registers to:
(d) If using the Timer Output alternate function, set the initial output level (High or
(e) Set the INTERRUPT mode.
to the relevant interrupt registers.
Timer Output alternate function.
the appropriate input transition occurs.
(a) Disable the timer.
(b) Configure the timer for CONTINUOUS mode.
(c) Set the prescale value.
(d) If using the Timer Output alternate function, set the initial output level (High or
Low) via the
Low) through
TPOL
TPOL
bit.
.
(Reload Value – Start Value + 1) x Prescaler
System Clock Frequency (Hz)
Z8FMC16100 Series Flash MCU
Product Specification
Timer Operating Modes
0001h
,
93