Z8FMC160100KITG Zilog, Z8FMC160100KITG Datasheet - Page 21

• Manufacturer Part Number: Z8FMC160100KITG
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KITG

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphical User Interface
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4660

Table 1. Signal Descriptions (Continued)
PS024613-0910
Signal Mnemonic
Analog
ANA[7:0]
V
CINP
CINN
COMPOUT
OPINP
OPINN
OPOUT
Oscillators
X
X
On-Chip Debugger
DBG
Reset–PWM Fault
RESET
REF
IN
OUT
Caution
Caution
/
FAULT0
I/O
I/O
I/O
I/O
O
O
O
I
I
I
I
I
I
Description
Analog Input: These signals are inputs to the ADC.
Voltage buffer output: This signal provides reference voltage for external
components.
If using the internal reference voltage generator, a 10 µF capacitor must
be placed on this pin to Ground.
Comparator positive input.
Comparator negative input.
Comparator output.
Operational amplifier positive input.
Operational amplifier negative input.
Operational amplifier output.
The External Crystal Input is the input pin to the crystal oscillator. A crystal
can be connected between it and the X
In addition, this pin is used with external RC networks or external clock
drivers to provide the system clock.
External Crystal Output: This pin is the output of the crystal oscillator.
A crystal is connected between it and the X
This pin must be left unconnected when not using a crystal.
Debug: This open-drain pin provides the single-pin control and data
interface to the OCD. For operation of the OCD, all power pins (V
be supplied with power, and all ground pins (V
This pin is open-drain and must have an external pull-up resistor to ensure
proper operation.
The default state of the
Flash Option2 byte in location 0001 as either 1=RESET or 0=FAULT0.
Subsequent change to FLTSEL bit0 in RSTSTAT register by software can
set the pin to either 0=RESET or 1=FAULT0.
RESET
pin is determined by FLTSEL bit7 in user
Z8FMC16100 Series Flash MCU
OUT
IN
pin to form the oscillator.
pin to form the oscillator.
SS
) must be grounded.
Product Specification
Signal Descriptions
DD
) must
9