Z8FMC160100KITG Zilog, Z8FMC160100KITG Datasheet - Page 124

• Manufacturer Part Number: Z8FMC160100KITG
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KITG

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphical User Interface
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4660

PS024613-0910
Transmitting Data using Interrupt-Driven Method
5. Check the TDRE bit in the LIN-UART Status 0 register to determine if the Transmit
6. If in MULTIPROCESSOR mode, write the LIN-UART Control 1 register to select the
7. Write the data byte to the LIN-UART Transmit Data register. The transmitter
8. If appropriate, and if MULTIPROCESSOR mode is enabled, make any changes to the
9. To transmit additional bytes, return to Step 4.
The LIN-UART Transmitter interrupt indicates the availability of the Transmit Data register
to accept new data for transmission. Follow the steps below to configure the LIN-UART for
interrupt-driven data transmission:
1. Write to the LIN-UART Baud Rate High and Low Byte registers to set the appropriate
2. Enable the LIN-UART pin functions by configuring the associated GPIO port pins for
3. Execute a DI instruction to disable interrupts.
4. Write to the Interrupt control registers to enable the LIN-UART Transmitter interrupt
5. If multiprocessor mode is appropriate, write to the LIN-UART Control 1 register to
6. Write to the LIN-UART Control 0 register to:
7. Execute an EI instruction to enable interrupts.
Data register is empty (indicated by a 1). If empty, continue to Step 6. If the Transmit
Data register is full (indicated by a 0), continue to monitor the TDRE bit until the
Transmit Data register becomes available to receive new data.
outgoing address bit. Set the Multiprocessor Bit Transmitter (
address byte; clear it if sending a data byte.
automatically transfers the data to the Transmit Shift register and transmits the data.
Multiprocessor Bit Transmitter (
baud rate.
alternate function operation.
and set the appropriate priority.
enable Multiprocessor (9-bit) mode functions.
Set the MULTIPROCESSOR Mode Select (MPEN) to Enable MULTIPROCESSOR
mode.
(a) Set the transmit enable bit (
(b) If multiprocessor mode is not enabled, enable parity, if appropriate, and select
(c) Set or clear the CTSE bit to enable or disable control from the remote receiver via
either even or odd parity.
the CTS pin.
TEN
MPBT
) to enable the LIN-UART for data transmission
) value.
Transmitting Data using Interrupt-Driven Method
Z8FMC16100 Series Flash MCU
Product Specification
MPBT
) if sending an
112