Z8FMC160100KITG Zilog, Z8FMC160100KITG Datasheet - Page 126

• Manufacturer Part Number: Z8FMC160100KITG
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KITG

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphical User Interface
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4660

PS024613-0910
Receiving Data using Interrupt-Driven Method
6. Read data from the LIN-UART Receive Data register. If operating in
7. Return to
The LIN-UART Receiver interrupt indicates the availability of new data (as well as error
conditions).
Follow the steps below to configure the LIN-UART receiver for interrupt-driven opera-
tion:
1. Write to the LIN-UART Baud Rate High and Low Byte registers to set the appropriate
2. Enable the LIN-UART pin functions by configuring the associated GPIO port pins for
3. Execute a DI instruction to disable interrupts.
4. Write to the Interrupt control registers to enable the LIN-UART Receiver interrupt and
5. Clear the LIN-UART Receiver interrupt in the applicable Interrupt Request register.
6. Write to the LIN-UART Control 1 register to enable MULTIPROCESSOR (9-bit)
7. Write the device address to the Address Compare register (automatic multiprocessor
8. Write to the LIN-UART Control 0 register to:
9. Execute an EI instruction to enable interrupts.
MULTIPROCESSOR (9-bit) mode, further actions may be required depending on the
Multiprocessor Mode bits
baud rate.
alternate function operation.
set the appropriate priority.
mode functions, if appropriate.
(a) Set the MULTIPROCESSOR Mode Select (MPEN) to Enable Multiprocessor
(b) Set the MULTIPROCESSOR Mode Bits, MPMD[1:0], to select the appropriate
(c) Configure the LIN-UART to interrupt on received data and errors or errors only
modes only).
(a) Set the receive enable bit (
(b) If MULTIPROCESSOR mode is not enabled, enable parity, if appropriate, and
mode.
address matching scheme.
(interrupt on errors only is unlikely to be useful for Z8FMC16100 Series Flash
MCU devices without a DMA block)
select either even or odd parity.
Step 5
to receive additional data.
MPMD
REN
[1:0].
) to enable the LIN-UART for data reception.
Receiving Data using Interrupt-Driven Method
Z8FMC16100 Series Flash MCU
Product Specification
114