Z8FMC160100KITG Zilog, Z8FMC160100KITG Datasheet - Page 112

• Manufacturer Part Number: Z8FMC160100KITG
• Description: KIT DEV FOR Z8 ENCORE Z8FMC16100
• Manufacturer: Zilog
• Series: Z8 Encore! MC™r

Specifications of Z8FMC160100KITG

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: Z8FMC16100
• Primary Attributes: 3-Ph DC Motors
• Secondary Attributes: Graphical User Interface
• For Use With: 269-4664 - KIT ACC OPTO-ISO USB SMART CABLE269-4661 - KIT ACC ETHERNET SMART CABLE269-4539 - KIT ACCESSORY USB SMART CABLE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-4660

PS024613-0910
Caution:
Reading the Timer Count Values
Timer 0 High and Low Byte Registers
Follow the steps below for configuring a timer for GATED mode and initiating the count:
1. Write to the Timer Control registers to:
2. Write to the Timer High and Low Byte registers to set the starting count value. This
3. Write to the Timer Reload High and Low Byte registers to set the reload value.
4. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing
5. Configure the timer interrupt to be generated only at the input deassertion event, the
6. Configure the associated GPIO port pin for the Timer Input alternate function.
7. Write to the Timer Control 1 register to enable the timer.
8. The timer counts when the Timer Input is equal to the
The current count value in the timers can be read while counting (enabled). This Read has
no effect on timer operation. When the timer is enabled and the Timer High Byte register
is read, the contents of the Timer Low Byte register are placed into a holding register. A
subsequent Read from Timer Low Byte register returns the value in the holding register.
This operation allows accurate Reads of the full 16-bit timer count value while enabled.
When the timer is not enabled, a Read from the Timer Low Byte register returns the actual
value in the counter.
The Timer 0 High and Low Byte (T0H and T0L) registers
the current 16-bit timer count value. When the timer is enabled, a Read from T0H causes the
value in T0L to be stored in a temporary holding register. A Read from T0L always returns
this temporary register when the timer is enabled. When the timer is disabled, Reads from
the T0L are direct from this temporary register.
Writing to the Timer High and Low Byte registers while the timer is enabled is not
recommended. There are no temporary holding registers available for Write operations;
therefore, simultaneous 16-bit Writes are not possible.
(a) Disable the timer.
(b) Configure the timer for GATED mode.
(c) Set the prescale value.
(d) Select the active state of the Timer Input through the
setting only affects the first pass in GATED mode. After the first timer reset in
GATED mode, counting begins at the reset value of
to the relevant interrupt registers.
reload event, or both, by setting the
TICONFIG
field of the Timer Control 0 register.
Z8FMC16100 Series Flash MCU
0001h
(Table 58
TPOL
Reading the Timer Count Values
TPOL
.
Product Specification
bit.
bit.
and
Table
59) contain
100