OM13013,598 NXP Semiconductors, OM13013,598 Datasheet - Page 316

• Manufacturer Part Number: OM13013,598
• Description: BOARD DEMO IAR LPC1227 JLINKLITE
• Manufacturer: NXP Semiconductors
• Series: -r

Specifications of OM13013,598

• Design Resources: LPC122x-SK Brd Schematic
• Processor To Be Evaluated: LPC1227
• Processor Series: LPC122x
• Data Bus Width: 32 bit
• Interface Type: UART, SSP, SPI, I2C
• Cpu Core: ARM Cortex-M0
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3 V to 3.6 V
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-6885

NXP Semiconductors
UM10441
User manual
20.7.12 Read Boot code version number
20.7.13 Compare <address1> <address2> <no of bytes>
20.7.14 ReadUID
Table 302. ISP Read Boot Code version number command
Table 303. ISP Compare command
Table 304. ReadUID command
Command
Input
Return Code CMD_SUCCESS followed by 2 bytes of boot code version number in ASCII format.
Description
Command
Input
Return Code CMD_SUCCESS | (Source and destination data are equal)
Description
Example
Command
Input
Return Code CMD_SUCCESS followed by four 32-bit words of E-sort test information in ASCII
Description
K
None
It is to be interpreted as <byte1(Major)>.<byte0(Minor)>.
This command is used to read the boot code version number.
M
Address1 (DST): Starting flash or RAM address of data bytes to be compared.
This address should be a word boundary.
Address2 (SRC): Starting flash or RAM address of data bytes to be compared.
This address should be a word boundary.
Number of Bytes: Number of bytes to be compared; should be a multiple of 4.
COMPARE_ERROR | (Followed by the offset of first mismatch)
COUNT_ERROR (Byte count is not a multiple of 4) |
ADDR_ERROR |
ADDR_NOT_MAPPED |
PARAM_ERROR |
This command is used to compare the memory contents at two locations.
Compare result may not be correct when source or destination address
contains any of the first 512 bytes starting from address zero. First 512 bytes
are re-mapped to boot ROM
"M 8192 268468224 4<CR><LF>" compares 4 bytes from the RAM address
0x1000 8000 to the 4 bytes from the flash address 0x2000.
N
None
format. The word sent at the lowest address is sent first.
This command is used to read the unique ID.
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 15 February 2011
Chapter 20: LPC122x Flash ISP/IAP
UM10441
© NXP B.V. 2011. All rights reserved.
316 of 442