OM13013,598 NXP Semiconductors, OM13013,598 Datasheet - Page 333

• Manufacturer Part Number: OM13013,598
• Description: BOARD DEMO IAR LPC1227 JLINKLITE
• Manufacturer: NXP Semiconductors
• Series: -r

Specifications of OM13013,598

• Design Resources: LPC122x-SK Brd Schematic
• Processor To Be Evaluated: LPC1227
• Processor Series: LPC122x
• Data Bus Width: 32 bit
• Interface Type: UART, SSP, SPI, I2C
• Cpu Core: ARM Cortex-M0
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3 V to 3.6 V
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 568-6885

NXP Semiconductors
UM10441
User manual
21.6.12 Channel enable clear register
21.6.11 Channel enable set register
Table 330. Channel request mask clear register (CHNL_REQ_MASK_CLR, address 0x4004
This register is a read/write register and enables a DMA channel c (c = 0 to 20). Reading
the register returns the enable status of the channels. Writing to a bit where a DMA
channel is not implemented has no effect.
Table 331. Channel enable set register (CHNL_ENABLE_SET, address 0x4004 C028) bit
This register is a write-only register and disables a DMA channel. Writing to a bit where a
DMA channel is not implemented has no effect.
Remark: The controller disables a channel by setting the appropriate bit when either:
Bit
20:0
31:21 -
Bit
20:0
31:21 -
•
•
•
The controller completes the DMA cycle.
The controller reads a channel_cfg memory location which has cycle_ctrl = 000.
An error occurs on the AHB-Lite bus.
Symbol
CHNL_ENABLE_
SET
Symbol
CHNL_REQ_
MASK_CLR
C024) bit description
description
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 15 February 2011
Chapter 21: LPC122x General purpose micro DMA controller
Description
Set the appropriate bit to enable DMA requests for the channel
corresponding to dma_req[c] and dma_sreq[c].
Write as:
Bit [c] = 0: No effect. Use the chnl_req_mask_set Register to
disable dma_req[c] and dma_sreq[c] from generating requests.
Bit [c] = 1: Enables dma_req[c] or dma_sreq[c] to generate
DMA requests.
Reserved.
Description
Returns the enable status of the channels, or enables the
corresponding channels.
Read as:
Bit [c] = 0: Channel c is disabled.
Bit [c] = 1 Channel c is enabled.
Write as:
Bit [c] = 0: No effect. Use the CHNL_ENABLE_CLR Register
to disable a channel.
Bit [c] = 1: Enables channel c.
Reserved.
UM10441
© NXP B.V. 2011. All rights reserved.
333 of 442
Reset
value
0x0
-
Reset
value
-
-