mc9s12vr48 Freescale Semiconductor, Inc, mc9s12vr48 Datasheet - Page 222

no-image

mc9s12vr48

Manufacturer Part Number
mc9s12vr48
Description
S12 Microcontrollers
Manufacturer
Freescale Semiconductor, Inc
Datasheet
S12S Debug Module (S12SDBGV2)
for a valid match. Similarly the SZE and SZ bits allow the size of access (word or byte) to be considered
in the compare. Only comparators A and B feature SZE and SZ.
The TAG bit in each comparator control register is used to determine the match condition. By setting TAG,
the comparator qualifies a match with the output of opcode tracking logic and a state sequencer transition
occurs when the tagged instruction reaches the CPU execution stage. Whilst tagging the RW, RWE, SZE,
and SZ bits and the comparator data registers are ignored; the comparator address register must be loaded
with the exact opcode address.
If the TAG bit is clear (forced type match) a comparator match is generated when the selected address
appears on the system address bus. If the selected address is an opcode address, the match is generated
when the opcode is fetched from the memory, which precedes the instruction execution by an indefinite
number of cycles due to instruction pipelining. For a comparator match of an opcode at an odd address
when TAG = 0, the corresponding even address must be contained in the comparator register. Thus for an
opcode at odd address (n), the comparator register must contain address (n–1).
Once a successful comparator match has occurred, the condition that caused the original match is not
verified again on subsequent matches. Thus if a particular data value is verified at a given address, this
address may not still contain that data value when a subsequent match occurs.
Match[0, 1, 2] map directly to Comparators [A, B, C] respectively, except in range modes (see
Section 6.3.2.4, “Debug Control Register2
the priority section
6.4.2.1
With range comparisons disabled, the match condition is an exact equivalence of address bus with the
value stored in the comparator address registers. Further qualification of the type of access (R/W,
word/byte) and databus contents is possible, depending on comparator channel.
6.4.2.1.1
Comparator C offers only address and direction (R/W) comparison. The exact address is compared, thus
with the comparator address register loaded with address (n) a word access of address (n–1) also accesses
(n) but does not cause a match.
222
1
A word access of ADDR[n-1] also accesses ADDR[n] but does not generate a match.
The comparator address register must contain the exact address from the code.
Read and write accesses of ADDR[n]
Condition For Valid Match
Write accesses of ADDR[n]
Read accesses of ADDR[n]
Single Address Comparator Match
Comparator C
(Section 6.4.3.4, “Channel
Table 6-32. Comparator C Access Considerations
MC9S12VR Family Reference Manual,
Preliminary - Subject to Change Without Notice
(DBGC2)). Comparator channel priority rules are described in
Comp C Address RWE
Priorities).
ADDR[n]
ADDR[n]
ADDR[n]
1
0
1
1
Rev. 2.2
RW
X
0
1
LDAA ADDR[n]
STAA #$BYTE ADDR[n]
STAA #$BYTE ADDR[n]
LDAA #$BYTE ADDR[n]
Freescale Semiconductor
Examples

Related parts for mc9s12vr48