mc9s12vr48 Freescale Semiconductor, Inc, mc9s12vr48 Datasheet - Page 499

• Manufacturer Part Number: mc9s12vr48
• Description: S12 Microcontrollers
• Manufacturer: Freescale Semiconductor, Inc

Table
containing the backdoor comparison key to avoid code runaway.
Upon clearing CCIF to launch the Verify Backdoor Access Key command, the Memory Controller will
check the FSEC KEYEN bits to verify that this command is enabled. If not enabled, the Memory
Controller sets the ACCERR bit in the FSTAT register and terminates. If the command is enabled, the
Memory Controller compares the key provided in FCCOB to the backdoor comparison key in the Flash
configuration field with Key 0 compared to 0x3_FF00, etc. If the backdoor keys match, security will be
released. If the backdoor keys do not match, security is not released and all future attempts to execute the
Verify Backdoor Access Key command are aborted (set ACCERR) until a reset occurs. The CCIF flag is
set after the Verify Backdoor Access Key operation has completed.
17.4.6.12 Set User Margin Level Command
The Set User Margin Level command causes the Memory Controller to set the margin level for future read
operations of the P-Flash or EEPROM block.
Freescale Semiconductor
17-3). The Verify Backdoor Access Key command must not be executed from the Flash block
Register
FSTAT
Table 17-50. Verify Backdoor Access Key Command FCCOB Requirements
CCOBIX[2:0]
Table 17-52. Set User Margin Level Command FCCOB Requirements
Table 17-51. Verify Backdoor Access Key Command Error Handling
000
001
CCOBIX[2:0]
MGSTAT1
MGSTAT0
ACCERR
Error Bit
FPVIOL
000
001
010
011
100
MC9S12VR Family Reference Manual, Rev. 2.2
Preliminary - Subject to Change Without Notice
Set if CCOBIX[2:0] != 100 at command launch
Set if an incorrect backdoor key is supplied
Set if backdoor key access has not been enabled (KEYEN[1:0] != 10, see
Section
Set if the backdoor key has mismatched since the last reset
None
None
None
0x0D
17.3.2.2)
0x0C
FCCOB Parameters
FCCOB Parameters
Margin level setting
Key 0
Key 1
Key 2
Key 3
Global address [17:16] to identify the
Error Condition
Not required
Flash block
64 KByte Flash Module (S12FTMRG64K512V1)
499