MPC564MZP56 Freescale Semiconductor, MPC564MZP56 Datasheet - Page 143

• Manufacturer Part Number: MPC564MZP56
• Description: IC MCU 512K FLASH 56MHZ 388-BGA
• Manufacturer: Freescale Semiconductor
• Series: MPC5xxr

Specifications of MPC564MZP56

• Core Processor: PowerPC
• Core Size: 32-Bit
• Speed: 56MHz
• Connectivity: CAN, EBI/EMI, SCI, SPI, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 56
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 2.5 V ~ 2.7 V
• Data Converters: A/D 32x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 388-BGA
• Core: PowerPC
• Processor Series: MPC5xx
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 56 MHz
• Data Ram Size: 32 KB
• On-chip Adc: Yes
• Number Of Programmable I/os: 56
• Number Of Timers: 2
• Operating Supply Voltage: 0 V to 5 V
• Mounting Style: SMD/SMT
• A/d Bit Size: 10 bit
• A/d Channels Available: 32
• Height: 1.95 mm
• Interface Type: CAN, JTAG, QSPI, SCI, SPI, UART
• Length: 27 mm
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Supply Voltage (max): 2.7 V, 5.25 V
• Supply Voltage (min): 2.5 V, 4.75 V
• Width: 27 mm
• For Use With: MPC564EVB - KIT EVAL FOR MPC561/562/563/564
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: No RoHS Version Available

Freescale Semiconductor
12
13
14
15
16
17
18
19
standby power supply.
An external pull-up is required in order to negate the signal in the appropriate time.
This pin is 5-V tolerant.
This signal was PD only until SPRDS is set on mask set K27S of the MPC561.
These values represent full drive, half drive and quarter drive.
Whether the Pull device is a pull-up or a pull-down is determined by the state of the PULL_SEL signal.
For this 5-V output, a drive load of 200 pf is possible, but will have a rise/fall time of 100ns.
MPC563 only, no connection on MPC561.
IRAMSTBY is the input to an approximately 1.7V voltage regulator. It should be connected through a resistor to a
MPC561/MPC563 Reference Manual, Rev. 1.2
Signal Descriptions
2-45