UPD70F3453GC-8EA-A Renesas Electronics America, UPD70F3453GC-8EA-A Datasheet - Page 224

• Manufacturer Part Number: UPD70F3453GC-8EA-A
• Description: MCU 32BIT 128KB FLASH 100LQFP
• Manufacturer: Renesas Electronics America
• Series: V850E/Ix3r

Specifications of UPD70F3453GC-8EA-A

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 64MHz
• Connectivity: CSI, EBI/EMI, I²C, UART/USART
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 56
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3.5 V ~ 5.5 V
• Data Converters: A/D 10x12b, 8x10b
• Oscillator Type: External
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

with the count clock, and the counter starts counting. At this time, the output of the TOAm0 pin is inverted.
Additionally, the set value of the TAAnCCR0 register is transferred to the CCR0 buffer register.
cleared to 0000H, the output of the TOAm0 pin is inverted, and a compare match interrupt request signal
(INTTAnCC0) is generated.
222
When the TAAnCE bit is set to 1, the value of the 16-bit counter is cleared from FFFFH to 0000H in synchronization
When the count value of the 16-bit counter matches the value of the CCR0 buffer register, the 16-bit counter is
The interval can be calculated by the following expression.
Interval = (Set value of TAAnCCR0 register + 1) × Count clock cycle
Remark
TAAnCTL1
TAAnCTL0
(a) TAAn control register 0 (TAAnCTL0)
(b) TAAn control register 1 (TAAnCTL1)
Note The TAAmEEE bit can be set to 1 only when timer output (TOAm1) is used. However, set the
V850E/IF3: n = 0 to 4, m = 2, 4
V850E/IG3: n = 0 to 4, m = 2 to 4
TAAaSYE
TAAnCE
0/1
TAAmCCR0 and TAAmCCR1 registers to the same value.
0
Figure 6-12. Register Setting for Interval Timer Mode Operation (1/3)
TAAmEST
0
0
CHAPTER 6 16-BIT TIMER/EVENT COUNTER AA (TAA)
TAAmEEE
0/1
0
Note
User’s Manual U18279EJ3V0UD
0
0
0
0
TAAnCKS2 TAAnCKS1 TAAnCKS0
TAAnMD2 TAAnMD1 TAAnMD0
0/1
0
0/1
0
0/1
0
0: Operate on count
1: Count with external
Select count clock
0: Stop counting
1: Enable counting
0, 0, 0:
Interval timer mode
clock selected by
TAAmCKS0 to
TAAmCKS2 bits
event count input signal