DF61654N50FTV Renesas Electronics America, DF61654N50FTV Datasheet - Page 676

• Manufacturer Part Number: DF61654N50FTV
• Description: IC H8SX/1654 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61654N50FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 14 Serial Communication Interface (SCI, IrDA, CRC)
Data transmission/reception using the DTC or DMAC is also possible in smart card interface
mode, similar to in the normal SCI mode. In transmission, the TEND and TDRE flags in SSR are
simultaneously set to 1, thus generating a TXI interrupt. This activates the DTC or DMAC by a
TXI request thus allowing transfer of transmit data if the TXI request is specified as a source of
DTC or DMAC activation beforehand. The TDRE and TEND flags are automatically cleared to 0
at data transfer by the DTC or DMAC. If an error occurs, the SCI automatically re-transmits the
same data. During re-transmission, the TEND flag remains as 0, thus not activating the DTC or
DMAC. Therefore, the SCI and DTC or DMAC automatically transmit the specified number of
bytes, including re-transmission in the case of error occurrence. However, the ERS flag in SSR,
which is set at error occurrence, is not automatically cleared; the ERS flag must be cleared by
previously setting the RIE bit in SCR to 1 to enable an ERI interrupt request to be generated at
error occurrence.
When transmitting/receiving data using the DTC or DMAC, be sure to set and enable the DTC or
DMAC prior to making SCI settings. For DTC or DMAC settings, see section 8, Data Transfer
Controller (DTC) and section 7, DMA Controller (DMAC).
In reception, an RXI interrupt request is generated when the RDRF flag in SSR is set to 1. This
activates the DTC or DMAC by an RXI request thus allowing transfer of receive data if the RXI
request is specified as a source of DTC or DMAC activation beforehand. The RDRF flag is
automatically cleared to 0 at data transfer by the DTC or DMAC. If an error occurs, the RDRF
flag is not set but the error flag is set. Therefore, the DTC or DMAC is not activated and an ERI
interrupt request is issued to the CPU instead; the error flag must be cleared.
Rev.1.00 Sep. 08, 2005 Page 626 of 966
REJ09B0219-0100