DF61654N50FTV Renesas Electronics America, DF61654N50FTV Datasheet - Page 846

• Manufacturer Part Number: DF61654N50FTV
• Description: IC H8SX/1654 MCU FLASH 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8SX/1600r

Specifications of DF61654N50FTV

• Core Processor: H8SX
• Core Size: 32-Bit
• Speed: 50MHz
• Connectivity: I²C, IrDA, SCI, SmartCard, USB
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 75
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• For Use With: HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)3DK1657 - DEV EVAL KIT FOR H8SX/1657
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 20 Flash Memory (0.18-µm F-ZTAT Version)
4. After all user MAT are automatically erased, the state of waiting for programming/erasing
(3)
• The clock of 48 MHz needs to be supplied to the USB module. Set the external clock
• Use the PM4 pin for the D+ pull-up control connection.
• For the stable supply of the power during the flash memory programming and erasing, the
• If the bus powered HUB is disconnected during the flash memory programming and erasing,
• If the USB bus in the bus power mode enters the suspend mode, this does not make the
Rev.1.00 Sep. 08, 2005 Page 796 of 966
REJ09B0219-0100
command is entered. When the programming command is received, the state shifts to the state
of waiting for programming data. The same applies to erasing. In addition to the commands for
programming/erasing, there are commands for performing sum check, blank check (erasure
check), and memory read of the user MAT, and acquiring the current status information.
frequency and clock pulse generator so as to supply 48 MHz as the clock for the USB (cku).
For details, refer to section 21, Clock Pulse Generator.
cable should not be connected via the bus powered HUB.
permanent damage to the LSI may result.
transition to the software standby mode of the power-down mode.
Notes on USB Boot Mode Execution