upd78f9211grt2-jjg-a ETC-unknow, upd78f9211grt2-jjg-a Datasheet - Page 196

• Manufacturer Part Number: upd78f9211grt2-jjg-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: ETC-unknow

13.4 Cautions for Power-on-Clear Circuit
voltage (V
release of reset to the start of the operation of the microcontroller can be arbitrarily set by taking the following action.
<Action>
software counter that uses a timer, and then initialize the ports.
• If supply voltage fluctuation is 50 ms or less in vicinity of POC detection voltage
196
Note 1
In a system where the supply voltage (V
After releasing the reset signal, wait for the supply voltage fluctuation period of each system by means of a
Notes 1.
POC
2.
), the system may be repeatedly reset and released from the reset status. In this case, the time from
No
If reset is generated again during this period, initialization processing <2> is not started.
A flowchart is shown on the next page.
Figure 13-3. Example of Software Processing After Release of Reset (1/2)
Setting 8-bit timer H1
(50 ms
50 ms has passed?
processing <1>
processing <2>
(TMIFH1 = 1?)
Initialization
Clears WDT
Initialization
Reset
is measured)
Yes
Power-on clear
CHAPTER 13 POWER-ON-CLEAR CIRCUIT
DD
User’s Manual U16994EJ3V0UD
) fluctuates for a certain period in the vicinity of the POC detection
; Check reset source
;
; f
Initialization of ports
Specify the division ratio of the system clock,
setting Timaer, setting A/D Converter, etc.
Setting WDT
Source : f
Timer starts (TMHE1 = 1)
XP
= High-speed internal oscillation clock (8.4 MHz (MAX.)) /2
RL
(2.1 MHz (MAX.)) /2
51 ms when the compare value is 25
Note 2
12
,
2
(default value)