upd78f9211grt2-jjg-a ETC-unknow, upd78f9211grt2-jjg-a Datasheet - Page 203

• Manufacturer Part Number: upd78f9211grt2-jjg-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: ETC-unknow

(2) When used as interrupt
• When starting operation
<1> Mask the LVI interrupt (LVIMK = 1).
<2> Set the detection voltage using bits 3 to 0 (LVIS3 to LVIS0) of the low-voltage detection level select
<3> Set bit 7 (LVION) of LVIM to 1 (enables LVI operation).
<4> Use software to instigate a wait of at least 0.2 ms.
<5> Wait until “supply voltage (V
<6> Clear the interrupt request flag of LVI (LVIIF) to 0.
<7> Release the interrupt mask flag of LVI (LVIMK).
<8> Execute the EI instruction (when vector interrupts are used).
Figure 14-5 shows the timing of generating the interrupt signal of the low-voltage detector. Numbers <1> to
<7> in this figure correspond to <1> to <7> above.
• When stopping operation
Either of the following procedures must be executed.
•
•
When using 8-bit memory manipulation instruction: Write 00H to LVIM.
When using 1-bit memory manipulation instruction: Clear LVION to 0.
register (LVIS).
CHAPTER 14 LOW-VOLTAGE DETECTOR
DD
) ≥ detection voltage (V
User’s Manual U16994EJ3V0UD
LVI
)” at bit 0 (LVIF) of LVIM is confirmed.
203