upd78f9211grt2-jjg-a ETC-unknow, upd78f9211grt2-jjg-a Datasheet - Page 240

• Manufacturer Part Number: upd78f9211grt2-jjg-a
• Description: 8-bit Single-chip Microcontrollers
• Manufacturer: ETC-unknow

16.8.7 Example of block blank check operation in self programming mode
240
An example of the block blank check operation in self programming mode is explained below.
<1> Set 04H (block blank check) to the flash program command register (FLCMD).
<2> Set the number of block for which a blank check is performed, to flash address pointer H (FLAPH).
<3> Set flash address pointer L (FLAPL) to 00H.
<4> Write the same value as FLAPH to the flash address pointer H compare register (FLAPHC).
<5> Set the flash address pointer L compare register (FLAPLC) to FFH.
<6> Clear the flash status register (PFS).
<7> Write ACH to the watchdog timer enable register (WDTE) (clear and restart the watchdog timer counter)
<8> Execute the HALT instruction then start self programming. (Execute an instruction immediately after the
<9> Check if a self programming error has occurred using bit 1 (VCERR) and bit 2 (WEPRERR) of PFS.
<10> Block blank check is abnormally terminated.
<11> Block blank check is normally terminated.
Note This setting is not required when the watchdog timer is not used.
HALT instruction if self programming has been executed.)
Abnormal → <10>
Normal
→ <11>
CHAPTER 16 FLASH MEMORY
User’s Manual U16994EJ3V0UD
Note
.