H8S2110B RENESAS [Renesas Technology Corp], H8S2110B Datasheet - Page 118

• Manufacturer Part Number: H8S2110B
• Description: Renesas 16-Bit Single-Chip Microcomputer Renesas H8S Family/H8S/2100 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 5 Interrupt Controller
3. An interrupt request with interrupt control level 1 is accepted when the I bit is cleared to 0, or
4. When the CPU accepts an interrupt request, it starts interrupt exception handling after
5. The PC and CCR are saved to the stack area by interrupt exception handling. The PC saved on
6. The I and UI bits in CCR are set to 1. This masks all interrupts except for an NMI or address
7. The CPU generates a vector address for the accepted interrupt and starts execution of the
Rev. 2.00 Mar 21, 2006 page 80 of 518
REJ09B0299-0200
interrupt request with the highest priority is accepted according to the priority order, an
interrupt handling is requested to the CPU, and other interrupt requests are held pending.
when the I bit is set to 1 while the UI bit is cleared to 0.
An interrupt request with interrupt control level 0 is accepted when the I bit is cleared to 0.
When the I bit is set to 1, only an NMI or address break interrupt request is accepted, and other
interrupts are held pending.
When both the I and UI bits are set to 1, only an NMI or address break interrupt request is
accepted, and other interrupts are held pending.
When the I bit is cleared to 0, the UI bit is not affected.
execution of the current instruction has been completed.
the stack shows the address of the first instruction to be executed after returning from the
interrupt handling routine.
break interrupt.
interrupt handling routine at the address indicated by the contents of the vector address in the
vector table.