H8S2110B RENESAS [Renesas Technology Corp], H8S2110B Datasheet - Page 358

• Manufacturer Part Number: H8S2110B
• Description: Renesas 16-Bit Single-Chip Microcomputer Renesas H8S Family/H8S/2100 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 13 I
In slave transmit mode, the slave device outputs the transmit data, while the master device outputs
the receive clock and returns an acknowledge signal. The transmission procedure and operations
in slave transmit mode are described below.
1. Initialize slave receive mode and wait for slave address reception.
2. When the slave address matches in the first frame following detection of the start condition,
3. After clearing the IRIC flag to 0, write data to ICDR. At this time, the ICDRE flag is cleared to
4. The master device drives SDA low at the 9th clock pulse, and returns an acknowledge signal.
5. To continue transmission, write the next data to be transmitted into ICDR. The ICDRE flag is
Transmit operations can be performed continuously by repeating steps [4] and [5].
6. Clear the IRIC flag to 0.
7. To end transmission, clear the ACKE bit in ICCR to 0, to clear the acknowledge bit stored in
8. Clear the TRS bit to 0 for the next address reception, to set slave receive mode.
9. Dummy-read ICDR to release SDA on the slave side.
Rev. 2.00 Mar 21, 2006 page 320 of 518
REJ09B0299-0200
the slave device drives SDA low at the 9th clock pulse and returns an acknowledge signal. If
the 8th data bit (R/W) is 1, the TRS bit in ICCR is set to 1, and the mode changes to slave
transmit mode automatically. The IRIC flag is set to 1 at the rise of the 9th clock. If the IEIC
bit in ICCR has been set to 1, an interrupt request is sent to the CPU. At the same time, the
ICDRE flag is set to 1. The slave device drives SCL low from the fall of the transmit clock
until ICDR data is written, to disable the master device to output the next transfer clock.
0. The written data is transferred to ICDRS, and the ICDRE and IRIC flags are set to 1 again.
The slave device sequentially sends the data written into ICDRS in accordance with the clock
output by the master device.
The IRIC flag is cleared to 0 to detect the end of transmission. Processing from the ICDR
register writing to the IRIC flag clearing should be performed continuously. Prevent any other
interrupt processing from being inserted.
As this acknowledge signal is stored in the ACKB bit in ICSR, this bit can be used to
determine whether the transfer operation was performed successfully. When one frame of data
has been transmitted, the IRIC flag in ICCR is set to 1 at the rise of the 9th transmit clock
pulse. When the ICDRE flag is 0, the data written into ICDR is transferred to ICDRS,
transmission starts, and the ICDRE and IRIC flags are set to 1 again. If the ICDRE flag has
been set to 1, this slave device drives SCL low from the fall of the transmit clock until data is
written to ICDR.
cleared to 0. The IRIC flag is cleared to 0 to detect the end of transmission. Processing from
the ICDR register writing to the IRIC flag clearing should be performed continuously. Prevent
any other interrupt processing from being inserted.
the ACKB bit to 0.
2
C Bus Interface (IIC)