CJ1W-NC414 Omron, CJ1W-NC414 Datasheet - Page 261

• Manufacturer Part Number: CJ1W-NC414
• Description: High Speed Pulse Train 4 Axes
• Manufacturer: Omron

Specifications of CJ1W-NC414

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

CJ Position Control Units OPERATION MANUAL (CJ1W-NC214/234/414/434)
Details of Memory Operation Condition Data
Conditional Expression
This section explains memory operation condition data.
Select the conditional expression to use for comparison.
ON (bit comparison)
OFF (bit comparison) If the specified bit is OFF, the condition is deemed True.
AND (bit comparison) If both of the 2 specified bits are ON, the condition is deemed True.
OR (bit comparison)
Data comparison (2
words)
Timer (time
specification)
Counter (count
specification)
External interrupt
input
Condition
If the specified bit is ON, the condition is deemed True.
The specified bit is the data 1 bit.
The specified bit is the data 1 bit.
Specify the data 1 bit and data 2 bit.
If either of the 2 specified bits is ON, the condition is deemed True.
Specify the data 1 bit and data 2 bit.
If the comparison result of the specified 2 data is satisfied, the condition is
deemed True.
Specify the 2 words for comparison.
The condition is deemed True after a wait time specified in units of 10 ms.
Only specifying edge is enabled under [Edge Selection].
specify level.
Specify the count. Countdown continues every time the condition is referenced.
If the countdown result is 0, the condition is deemed False. If the result is other
than 0, the condition is deemed True.
Once the countdown result becomes "0," the count value is also reset.
specify edge.
An error also occurs if you set [Count specification] for any other than [FOR and
NEXT].
You can specify this input only for the sequence starting condition. If the external
interrupt input is ON, the condition is deemed True.
You can specify both edge and level for [Edge Selection]. If you specify edge,
an interrupt process starts when the external interrupt input turns from OFF to
ON.
You can select external interrupt input only for an axis which you specified in the
memory operation parameter configuration axis.
Only specifying level is enabled under [Edge Selection]. An error occurs if you
5-7 Memory Operation Condition Data
Judgment method
An error occurs if you
5-100
5