HD6432670 Hitachi, HD6432670 Datasheet - Page 153

• Manufacturer Part Number: HD6432670
• Description: (HD64F267x Series) 16-Bit Microcomputer
• Manufacturer: Hitachi

5.6
The interrupt controller has two modes: interrupt control mode 0 and interrupt control mode 2.
Interrupt operations differ depending on the interrupt control mode. The interrupt control mode is
selected by INTCR. Table 5.3 shows the differences between interrupt control mode 0 and
interrupt control mode 2.
Table 5.3
5.6.1
In interrupt control mode 0, interrupt requests except for NMI is masked by the I bit of CCR in the
CPU. Figure 5.3 shows a flowchart of the interrupt acceptance operation in this case.
1. If an interrupt source occurs when the corresponding interrupt enable bit is set to 1, an
2. If the I bit is set to 1, only an NMI interrupt is accepted, and other interrupt requests are held
3. Interrupt requests are sent to the interrupt controller, the highest-ranked interrupt according to
4. When the CPU accepts an interrupt request, it starts interrupt exception handling after
5. The PC and CCR are saved to the stack area by interrupt exception handling. The PC saved on
6. Next, the I bit in CCR is set to 1. This masks all interrupts except NMI.
7. The CPU generates a vector address for the accepted interrupt and starts execution of the
Interrupt
Control Mode Registers
0
2
interrupt request is sent to the interrupt controller.
pending. If the I bit is cleared, an interrupt request is accepted.
the priority system is accepted, and other interrupt requests are held pending.
execution of the current instruction has been completed.
the stack shows the address of the first instruction to be executed after returning from the
interrupt handling routine.
interrupt handling routine at the address indicated by the contents of the vector address in the
vector table.
Interrupt Control Modes and Interrupt Operation
Interrupt Control Mode 0
Interrupt Control Modes
Priority Setting
Default
IPR
Interrupt
Mask Bits Description
I
I2 to I0
The priorities of interrupt sources are fixed at
the default settings.
Interrupt sources except for NMI is masked by
the I bit.
8 priority levels except for NMI can be set with
IPR.
8-level interrupt mask control is performed by
bits I2 to I0.
Rev. 2.0, 04/02, page 107 of 906