HD6432670 Hitachi, HD6432670 Datasheet - Page 787

• Manufacturer Part Number: HD6432670
• Description: (HD64F267x Series) 16-Bit Microcomputer
• Manufacturer: Hitachi

Product Classification
H8S/2678 Series
The features of the flash memory included in the flash memory version are summarized below.
The block diagram of the flash memory is shown in figure 19.1.
19.1
ROMF251A_000020020400
Size
Programming/erase methods
The flash memory is programmed 128 bytes at a time. Erase is performed in single-block
units. The flash memory of 384 kbytes is configured as follows: 64 kbytes 5 blocks, 32
kbytes 1 block, and 4 kbytes 8 block. The 256-kbyte flash memory is configured as
follows: 64 kbytes 3 blocks, 32 kbytes 1 block, and 4 kbytes 8 blocks. To erase the
entire flash memory, each block must be erased in turn.
Reprogramming capability
The flash memory can be reprogrammed up to 100 times.
Two on-board programming modes
Boot mode
User program mode
On-board programming/erasing can be done in boot mode in which the on-chip boot program
is started for erase or programming of the entire flash memory. In normal user program mode,
individual blocks can be erased or programmed.
Programmer mode
Flash memory can be programmed/erased in programmer mode, using a PROM programmer,
as well as in on-board programming mode.
Automatic bit rate adjustment
With data transfer in boot mode, the bit rate of this LSI can be automatically adjusted to match
the transfer bit rate of the host.
Flash memory emulation by RAM
Part of the RAM area can be overlapped onto flash memory, to emulate flash memory updates
in real time.
Programming/erasing protection
There are three protect modes, hardware, software, and error protect, which allow protected
status to be designated for flash memory program/erase operations.
Features
Section 19 Flash Memory (F-ZTAT Version)
HD64F2676
ROM Size
256 kbytes
ROM Address
H'000000 to H'03FFFF (Modes 3, 4, 7, 10, and 11)
H'100000 to H'13FFFF (Modes 5, 6, 13, and 14)
Rev. 2.0, 04/02, page 741 of 906