DF2505BR26DV Renesas Electronics America, DF2505BR26DV Datasheet - Page 487

• Manufacturer Part Number: DF2505BR26DV
• Description: IC H8S/2505 MCU FLASH 176-LFBGA
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2500r

Specifications of DF2505BR26DV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 26MHz
• Connectivity: I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 104
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 176-LFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Clear DR to 0 and set DDR to 1
Write transmit data to TDR and
Read TDRE flag in SSR
Read TEND flag in SSR
Clear TE bit in SCR to 0
Clear TDRE flag to 0
set MPBT bit in SSR
All data transmitted?
Start transmission
Figure 13.11 Sample Multiprocessor Serial Transmission Flowchart
Break output?
Initialization
TDRE = 1
TEND = 1
<End>
Yes
Yes
Yes
Yes
No
No
No
No
[1]
[2]
[3]
[4]
[1] SCI initialization:
[2] SCI status check and transmit
[3] Serial transmission continuation
[4] Break output at the end of serial
Note: * The case, where the TDRE flag is
The TxD pin is automatically
designated as the transmit data
output pin.
After the TE bit is set to 1, a
frame of 1s is output, and
transmission is enabled.
data write:
Read SSR and check that the
TDRE flag is set to 1, then write
transmit data to TDR. Set the
MPBT bit in SSR to 0 or 1.
Finally, clear the TDRE flag to 0.
procedure:
To continue serial transmission,
be sure to read 1 from the TDRE
flag to confirm that writing is
possible, then write data to TDR,
and then clear the TDRE flag to
0. Checking and clearing of the
TDRE flag is automatic when the
DTC* is activated by a transmit
data empty interrupt (TXI)
request, and data is written to
TDR.
transmission:
To output a break in serial
transmission, set the port DR to
0, set DDR to 1, then clear the
TE bit in SCR to 0.
Section 13 Serial Communication Interface (SCI)
occurs only when the DISEL bit in DTC is 0
with the transfer counter other than 0.
Therefore, when the DISEL bit is 1, or
both the DISEL bit and the transfer counter are 0,
give the CPU an instruction to clear the TDRE flag.
automatically cleared by DTC,
Rev. 6.00 Sep. 24, 2009 Page 439 of 928
REJ09B0099-0600