DF2505BR26DV Renesas Electronics America, DF2505BR26DV Datasheet - Page 493

• Manufacturer Part Number: DF2505BR26DV
• Description: IC H8S/2505 MCU FLASH 176-LFBGA
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2500r

Specifications of DF2505BR26DV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 26MHz
• Connectivity: I²C, SCI
• Peripherals: POR, PWM, WDT
• Number Of I /o: 104
• Program Memory Size: 384KB (384K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 176-LFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

13.6.2
Before transmitting and receiving data, the TE and RE bits in SCR should be cleared to 0, then the
SCI should be initialized as described in a sample flowchart in figure 13.15. When the operating
mode, or transfer format, is changed for example, the TE and RE bits must be cleared to 0 before
making the change using the following procedure. When the TE bit is cleared to 0, the TDRE flag
is set to 1. Note that clearing the RE bit to 0 does not change the contents of the RDRF, PER,
FER, and ORER flags, or the contents of RDR.
Note: In simultaneous transmit and receive operations, the TE and RE bits should both be cleared
SCI Initialization (Clocked Synchronous Mode)
Set TE and RE bits in SCR to 1, and
set RIE, TIE, TEIE, and MPIE bits
Clear TE and RE bits in SCR to 0
Set CKE1 and CKE0 bits in SCR
to 0 or set to 1 simultaneously.
Set data transfer format in
1-bit interval elapsed?
Set value in BRR
Start initialization
SMR and SCMR
<Transfer start>
(TE, RE bits 0)
Figure 13.15 Sample SCI Initialization Flowchart
Yes
Wait
No
[4]
[2]
[3]
[1]
[1] Set the clock selection in SCR. Be sure
[2] Set the data transfer format in SMR and
[3] Write a value corresponding to the bit
[4] Wait at least one bit interval, then set
Section 13 Serial Communication Interface (SCI)
to clear bits RIE, TIE, TEIE, and MPIE,
TE and RE, to 0.
SCMR.
rate to BRR. Not necessary if an
external clock is used.
the TE bit or RE bit in SCR to 1.
Also set the RIE, TIE TEIE, and MPIE
bits.
Setting the TE and RE bits enables the
TxD and RxD pins to be used.
Rev. 6.00 Sep. 24, 2009 Page 445 of 928
REJ09B0099-0600