R7M-AP10030-BS1 Omron, R7M-AP10030-BS1 Datasheet - Page 171

• Manufacturer Part Number: R7M-AP10030-BS1
• Description: MOTORSERVO FLAT 100W W/BRAKE&KEY
• Manufacturer: Omron

Specifications of R7M-AP10030-BS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R7MAP10030BS1

System Design and Installation
Servo Driver inrush current:
With low-speed no-fuse breakers, an inrush current 10 times the rated current flows for 0.02 sec-
onds. For a simultaneous inrush for multiple Servo Drivers, select a no-fuse-breaker with a 20-ms
allowable current greater than the total inrush current shown in the following table for the applicable
Servomotor models.
●
Use surge absorbers to absorb surges from power supply input lines due to lightning, abnormal volt-
ages, etc. When selecting surge absorbers, take into account the varistor voltage, the amount of
surge immunity, and the amount of energy resistance. The surge absorbers shown in the following
table are recommended.
Note 1. Refer to the manufacturers’ documentation for operating details.
Note 2. The surge immunity is for a standard impulse current of 8/20 µ s. If pulses are wide, either
●
Use the appropriate noise filter from among those in the following table for the Servo Driver power
supply.
Note The last 2 digits in the noise filter’s model number indicate the type of connection terminals
R7D-APA3L to -AP02L
R7D-AP04L
R7D-APA3H to -AP04H
R7D-AP08H
Okaya Electric Indus-
tries Co., Ltd.
R7D-APA3L to -AP01L
R7D-AP02L to -AP04L
R7D-APA3H to -AP02H
R7D-AP04H
R7D-AP08H
Surge Absorbers
Noise Filters for Power Supply Input
used. “07” indicates lead-wire terminals. There are also models with soldered faston terminals
(“06”) and screw terminals (“08”). Use the appropriate noise filter for the application. For
details, contact the manufacturer.
Servo Driver
Maker
decrease the current or change to a larger-capacity surge absorber.
Servo Driver
Single-phase
Three-phase
R·A·V-781BYZ-2
R·A·V-781BXZ-4
FN2070-10/07
FN2070-16/07
FN2070-6/07
FN2070-10/07
FN2070-16/07
FN258L-16/07
Model
Model
30
30
60
60
Control-circuit power supply
783 V
78 V
10 A
16 A
6 A
10 A
16 A
16 A
Max. limit
current
voltage
Rated
Noise filter for power supply input
250 V
250 V
250 V
480 V
Inrush current (A0-p)
voltage
1,000A
1,000 A
Rated
immunity
Surge
0.4 mA/phase
0.4 mA/phase
0.4 mA/phase
2.5 mA (at
250 Vrms, 50 Hz)
Leakage current* Manufacturer
90
90
90
130
Block
Main-circuit power supply
Type
For power supply
line
For power supply
line ground
Chapter 3
Schaffner
Schaffner
Schaffner
Remarks
3-31