R7M-AP10030-BS1 Omron, R7M-AP10030-BS1 Datasheet - Page 230

• Manufacturer Part Number: R7M-AP10030-BS1
• Description: MOTORSERVO FLAT 100W W/BRAKE&KEY
• Manufacturer: Omron

Specifications of R7M-AP10030-BS1

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: R7MAP10030BS1

5-5
Maintenance and Inspection Precautions
The periodic maintenance cycle depends on the installation environment and application conditions
of the Servomotor or Servo Driver. Recommended maintenance times are listed below for Servomo-
tors and Servo Drivers. Use these for reference in determining actual maintenance schedules.
■
• Recommended Periodic Maintenance
• The radial loads during operation (rotation) on timing pulleys and other components contacting
• When requesting repairs or investigations, separate them into Servomotors and reduction gears,
■
• Recommended Periodic Maintenance
5-16
Troubleshooting
!WARNING
!Caution
Bearings:
Reduction gear:
Oil seal:
belts is twice the still load. Consult with the belt and pulley manufacturers and adjust designs and
system settings so that the allowable shaft load is not exceeded even during operation. If a Servo-
motor is used under a shaft load exceeding the allowable limit, the Servomotor shaft can break, the
bearings can burn out, and other problems can occur.
and make separate requests for each product.
Servomotors
Servo Drivers
Application Conditions: Ambient Servomotor operating temperature of 40 ° C, within allowable
shaft load, rated operation (rated torque and r/min), installed as described in operation manual.
Aluminum analytical capacitors: 50,000 hours, at an ambient Servo Driver operating temperature
of 40 ° C, 80% output of the rated operation (rated torque), installed as described in operation man-
ual.
Axle fan: 30,000 hours, at an ambient Servo Driver operating temperature of 40 ° C and an ambient
humidity of 65%.
Servomotors and Servo Drivers contain many components and will operate properly
only when each of the individual components is operating properly. Some of the
electrical and mechanical components require maintenance depending on application
conditions. In order to ensure proper long-term operation of Servomotors and Drivers,
periodic inspection and part replacement is required according to the life of the
components.
Periodic Maintenance
Do not attempt to disassemble, repair, or modify any Units. Any attempt to do so
may result in malfunction, fire, or electric shock.
Resume operation only after transferring to the new Unit the contents of the data
required for operation. Not doing so may result in an unexpected operation.
20,000 hours
20,000 hours
5,000 hours
Chapter 5