DF2398TE20 Renesas Electronics America, DF2398TE20 Datasheet - Page 80

• Manufacturer Part Number: DF2398TE20
• Description: IC H8S MCU FLASH 256K 120TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2398TE20

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 87
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 120-TQFP, 120-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2398TE20; HD64F2398TE20

Figure 2-13 shows the stack after exception handling ends.
2.8.4
In this state the CPU executes program instructions in sequence.
2.8.5
This is a state in which the bus has been released in response to a bus request from a bus master other than the CPU. While
the bus is released, the CPU halts.
There is two more bus masters in addition to the CPU: the DMA contraler (DMAC) and data transfer controller (DTC).
For further details, refer to section 6, Bus Controller.
2.8.6
The power-down state includes both modes in which the CPU stops operating and modes in which the CPU does not stop.
There are three modes in which the CPU stops operating: sleep mode, software standby mode, and hardware standby
mode. There are also two other power-down modes: medium-speed mode, and module stop mode. In medium-speed mode
the CPU and other bus masters operate on a medium-speed clock. Module stop mode permits halting of the operation of
individual modules, other than the CPU. For details, refer to section 21, Power-Down Modes.
(1) Sleep Mode: A transition to sleep mode is made if the SLEEP instruction is executed while the software standby bit
(SSBY) in the standby control register (SBYCR) is cleared to 0. In sleep mode, CPU operations stop immediately after
execution of the SLEEP instruction. The contents of CPU registers are retained.
(2) Software Standby Mode: A transition to software standby mode is made if the SLEEP instruction is executed while
the SSBY bit in SBYCR is set to 1. In software standby mode, the CPU and clock halt and all MCU operations stop. As
long as a specified voltage is supplied, the contents of CPU registers and on-chip RAM are retained. The I/O ports also
remain in their existing states.
Rev.6.00 Oct.28.2004 page 50 of 1016
REJ09B0138-0600H
Program Execution State
Bus-Released State
Power-Down State
Advanced mode
SP
Note: *Ignored when returning.
(c) Interrupt control mode 0
Figure 2-13 Stack Structure after Exception Handling (Examples)
(24 bits)
CCR
PC
SP
(d) Interrupt control mode 2
Reserved*
(24 bits)
CCR
EXR
PC