MC9S12G FREESCALE [Freescale Semiconductor, Inc], MC9S12G Datasheet - Page 1057

• Manufacturer Part Number: MC9S12G
• Description: Ignores external trigger. Performs one conversion sequence and stops.
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

28.4.6.7
The Erase All Blocks operation will erase the entire P-Flash and EEPROM memory space.
Upon clearing CCIF to launch the Erase All Blocks command, the Memory Controller will erase the entire
Flash memory space and verify that it is erased. If the Memory Controller verifies that the entire Flash
memory space was properly erased, security will be released. During the execution of this command
(CCIF=0) the user must not write to any Flash module register. The CCIF flag will set after the Erase All
Blocks operation has completed.
28.4.6.8
The Erase Flash Block operation will erase all addresses in a P-Flash or EEPROM block.
Freescale Semiconductor
1
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.
If a Program Once phrase is initially programmed to 0xFFFF_FFFF_FFFF_FFFF, the Program Once command will
be allowed to execute again on that same phrase.
Register
Register
FSTAT
FSTAT
Erase All Blocks Command
Erase Flash Block Command
CCOBIX[2:0]
Table 28-44. Erase All Blocks Command FCCOB Requirements
MGSTAT1
MGSTAT0
MGSTAT1
MGSTAT0
ACCERR
ACCERR
Error Bit
Error Bit
FPVIOL
FPVIOL
000
Table 28-45. Erase All Blocks Command Error Handling
Table 28-43. Program Once Command Error Handling
MC9S12G Family Reference Manual, Rev.1.01
Set if CCOBIX[2:0] != 101 at command launch
Set if command not available in current mode (see
Set if an invalid phrase index is supplied
Set if the requested phrase has already been programmed
None
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
Set if CCOBIX[2:0] != 000 at command launch
Set if command not available in current mode (see
Set if any area of the P-Flash or EEPROM memory is protected
Set if any errors have been encountered during the verify operation
Set if any non-correctable errors have been encountered during the verify
operation
0x08
FCCOB Parameters
Error Condition
Error Condition
Not required
240 KByte Flash Module (S12FTMRG240K2V1)
Table
Table
28-27)
28-27)
1
1057