MC9S12G FREESCALE [Freescale Semiconductor, Inc], MC9S12G Datasheet - Page 330

• Manufacturer Part Number: MC9S12G
• Description: Ignores external trigger. Performs one conversion sequence and stops.
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

S12 Clock, Reset and Power Management Unit (S12CPMU)
10.1.2.2
For S12CPMU Wait Mode is the same as Run Mode.
10.1.2.3
This mode is entered by executing the CPU STOP instruction.
The voltage regulator is in Reduced Power Mode (RPM).
The API is available.
The Phase Locked Loop (PLL) is off.
The Internal Reference Clock (IRC1M) is off.
Core Clock, Bus Clock and BDM Clock are stopped.
Depending on the setting of the PSTP and the OSCE bit, Stop Mode can be differentiated between Full
Stop Mode (PSTP = 0 or OSCE=0) and Pseudo Stop Mode (PSTP = 1 and OSCE=1). In addition, the
behavior of the COP in each mode will change based on the clocking method selected by
COPOSCSEL[1:0].
330
•
•
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.
— The PLLCLK is on and used to qualify the external oscillator clock.
Full Stop Mode (PSTP = 0 or OSCE=0)
External oscillator (XOSCLCP) is disabled.
— If COPOSCSEL1=0:
— If COPOSCSEL1=1:
Pseudo Stop Mode (PSTP = 1 and OSCE=1)
External oscillator (XOSCLCP) continues to run.
— If COPOSCSEL1=0:
— If COPOSCSEL1=1:
The COP and RTI counters halt during Full Stop Mode.
After wake-up from Full Stop Mode the Core Clock and Bus Clock are running on PLLCLK
(PLLSEL=1). COP and RTI are running on IRCCLK (COPOSCSEL0=0, RTIOSCSEL=0).
During Full Stop Mode the COP is running on ACLK (trimmable internal RC-Oscillator clock)
and the RTI counter halts.
After wake-up from Full Stop Mode the Core Clock and Bus Clock are running on PLLCLK
(PLLSEL=1). The COP runs on ACLK and RTI is running on IRCCLK (COPOSCSEL0=0,
RTIOSCSEL=0).
If the respective enable bits are set (PCE=1 and PRE=1) the COP and RTI will continue to run
with a clock derived from the oscillator clock.
The clock configuration bits PLLSEL, COPOSCSEL0, RTIOSCSEL are unchanged.
If the respective enable bit for the RTI is set (PRE=1) the RTI will continue to run with a clock
derived from the oscillator clock.
Wait Mode
Stop Mode
MC9S12G Family Reference Manual,
Rev.1.01
Freescale Semiconductor