MC9S12G FREESCALE [Freescale Semiconductor, Inc], MC9S12G Datasheet - Page 324

• Manufacturer Part Number: MC9S12G
• Description: Ignores external trigger. Performs one conversion sequence and stops.
• Manufacturer: FREESCALE [Freescale Semiconductor, Inc]

Security (S12XS9SECV2)
memory and EEPROM, another reset into special single chip mode will cause the blank check to succeed
and the options/security byte can be programmed to “unsecured” state via BDM.
While the BDM is executing the blank check, the BDM interface is completely blocked, which means that
all BDM commands are temporarily blocked.
9.1.5
Unsecuring the microcontroller can be done by three different methods:
9.1.5.1
In normal modes (single chip and expanded), security can be temporarily disabled using the backdoor key
access method. This method requires that:
The backdoor key values themselves would not normally be stored within the application data, which
means the application program would have to be designed to receive the backdoor key values from an
external source (e.g. through a serial port).
The backdoor key access method allows debugging of a secured microcontroller without having to erase
the Flash. This is particularly useful for failure analysis.
9.1.6
In normal single chip mode (NS), security can also be disabled by erasing and reprogramming the security
bits within Flash options/security byte to the unsecured value. Because the erase operation will erase the
entire sector from 0xFE00–0xFFFF (0x7F_FE00–0x7F_FFFF), the backdoor key and the interrupt vectors
will also be erased; this method is not recommended for normal single chip mode. The application
software can only erase and program the Flash options/security byte if the Flash sector containing the Flash
options/security byte is not protected (see Flash protection). Thus Flash protection is a useful means of
preventing this method. The microcontroller will enter the unsecured state after the next reset following
the programming of the security bits to the unsecured value.
This method requires that:
324
1. Backdoor key access
2. Reprogramming the security bits
3. Complete memory erase (special modes)
•
•
•
This document is valid for the S12G96 and the S12G128 device. All information related to other devices is preliminary.
The backdoor key at 0xFF00–0xFF07 (= global addresses 0x3_FF00–0x3_FF07) has been
programmed to a valid value.
The KEYEN[1:0] bits within the Flash options/security byte select ‘enabled’.
In single chip mode, the application program programmed into the microcontroller must be
designed to have the capability to write to the backdoor key locations.
Unsecuring the Microcontroller
Reprogramming the Security Bits
Unsecuring the MCU Using the Backdoor Key Access
No word of the backdoor key is allowed to have the value 0x0000 or
0xFFFF.
MC9S12G Family Reference Manual,
NOTE
Rev.1.01
Freescale Semiconductor