MC9S08JM60CLH Freescale, MC9S08JM60CLH Datasheet - Page 295

• Manufacturer Part Number: MC9S08JM60CLH
• Manufacturer: Freescale

Specifications of MC9S08JM60CLH

• Cpu Family: HCS08
• Device Core Size: 8b
• Frequency (max): 24MHz
• Interface Type: SCI/SPI
• Total Internal Ram Size: 4KB
• # I/os (max): 51
• Number Of Timers - General Purpose: 8
• Operating Supply Voltage (typ): 3.3/5V
• Operating Supply Voltage (max): 5.5V
• Operating Supply Voltage (min): 2.7V
• On-chip Adc: 12-chx12-bit
• Instruction Set Architecture: CISC
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 64
• Package Type: LQFP
• Program Memory Type: Flash
• Program Memory Size: 60KB
• Lead Free Status / RoHS Status: Compliant

Chapter 17
Universal Serial Bus Device Controller (S08USBV1)
17.1
This chapter describes an universal serial bus device controller (S08USBV1) module that is based on the
Universal Serial Bus Specification Rev 2.0. The USB bus is designed to replace existing bus interfaces
such as RS-232, PS/2, and IEEE 1284 for PC peripherals.
The S08USBV1 module provides a single-chip solution for full-speed (12 Mbps) USB device applications,
and integrates the required transceiver with Serial Interface Engine (SIE), 3.3 V regualtor, Endpoint RAM
and other control logics.
17.1.1
The S08USBV1 requires two clock sources, the 24 MHz bus clock and a 48 MHz reference clock. The
48 MHz clock is sourced directly from MCGOUT. To achieve the 48 MHz clock rate, the MCG must be
configured properly for PLL engaged external (PEE) mode with an external crystal.
For USB operation, examples of MCG configuration using PEE mode include:
17.1.2
In USB suspend mode, the USB device current consumption is limited to 500 μA. When the USB device
goes into suspend mode, the firmware typically enters stop3 to meet the USB suspend requirements on
current consumption.
17.1.3
If using an external 3.3 V regulator as an input to V
V
(USBVREN = 1), do not connect an external supply to the V
3.9 V and 5.5 V for the internal 3.3 V regulator to operate correctly.
Freescale Semiconductor
DD
•
•
, must not fall below the input voltage at the V
2 MHz crystal – RDIV = 000 and VDIV = 0110
4 MHz crystal – RDIV = 001 and VDIV = 0110
Introduction
Clocking Requirements
Current Consumption in USB Suspend
3.3 V Regulator
Enabling LVD increases current consumption in stop3. Consequently, when
trying to satisfy USB suspend requirements, disabling LVD before entering
stop3.
MC9S08JM60 Series Data Sheet, Rev. 3
NOTE
USB33
USB33
(only when USBVREN = 0), the supply voltage,
pin. If using the internal 3.3 V regulator
USB33
pin. In this case, V
DD
must fall between
295