r8a77850anbg Renesas Electronics Corporation., r8a77850anbg Datasheet - Page 1507

• Manufacturer Part Number: r8a77850anbg
• Description: Renesas 32-bit Risc Microcomputer Superh? Risc Engine Family
• Manufacturer: Renesas Electronics Corporation.

4. If the operand bus is selected, a break occurs after executing the instruction which has satisfied
29.3.5
1. Sequential break conditions can be specified by setting the MFE and MFI bits in the match
2. For channel 1, the execution count break condition can also be included in the sequential break
3. If the match conditions for the first and second channels in the sequence are satisfied within a
• When the Match Condition is Satisfied at the Instruction Fetch Cycle for Both the First and
Instruction B is 0 instruction after instruction A
Instruction B is one instruction after instruction A Sequential operation is not guaranteed.
Instruction B is two or more instructions after
instruction A
the conditions and immediately before executing the next instruction. However, if the data
value is included in the match conditions, a break may occur after executing several
instructions after the instruction which has satisfied the conditions; therefore, it is impossible
to identify the instruction causing the break. If such a break has occurred for the delayed
branch instruction or its delayed slot, the break does not occur until the first instruction at the
branch destination.
However, do not specify the operand break for the delayed slot of the RTE instruction. And if
the data value is included in the match conditions, it is not allowed to set the break for the
preceding the RTE instruction by one to six instructions.
condition setting registers (CBR0 and CBR1). (Sequential break involves two cases such that
channel 0 break condition is satisfied then channel 1 break condition is satisfied, and vice
versa.) To use the sequential break function, clear the MFE bit of the match condition setting
register and the BIE bit of the match operation setting register of the first channel in the
sequence, and set the MFE bit and specify the number of the second channel in the sequence
using the MFI bit in the match condition setting register of the second channel in the sequence.
If the sequential break condition is set, the condition match flag is set every time the match
condition is satisfied for each channel. When the condition has been satisfied for the first
channel in the sequence but not for the second channel in the sequence, clear the condition
match flag for the first channel in the sequence in order to release the first channel in the
sequence from the match state.
conditions.
significantly short time, sequential operation may not be guaranteed in some cases, as shown
below.
Second Channels in the Sequence:
Sequential Break
Equivalent to setting the same addresses; do
not use this setting.
Sequential operation is guaranteed.
Rev.1.00 Jan. 10, 2008 Page 1477 of 1658
29. User Break Controller (UBC)
REJ09B0261-0100