DEMO9S12XEP100 Freescale Semiconductor, DEMO9S12XEP100 Datasheet - Page 1007

• Manufacturer Part Number: DEMO9S12XEP100
• Description: BOARD DEMO FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S12XEP100

• Contents: Board, Cables, CD
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

26.4.2.17 Program D-Flash Command
The Program D-Flash operation programs one to four previously erased words in the D-Flash user
partition. The Program D-Flash operation will confirm that the targeted location(s) were successfully
programmed upon completion.
Upon clearing CCIF to launch the Program D-Flash command, the user-supplied words will be transferred
to the Memory Controller and be programmed. The CCOBIX index value at Program D-Flash command
launch determines how many words will be programmed in the D-Flash block. No protection checks are
made in the Program D-Flash operation on the D-Flash block, only access error checks. The CCIF flag is
set when the operation has completed.
Freescale Semiconductor
FERSTAT
Register
FSTAT
A Flash word must be in the erased state before being programmed.
Cumulative programming of bits within a Flash word is not allowed.
Table 26-66. Erase Verify D-Flash Section Command Error Handling
CCOBIX[2:0]
Table 26-67. Program D-Flash Command FCCOB Requirements
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Error Bit
FPVIOL
000
001
010
011
100
101
MC9S12XE-Family Reference Manual , Rev. 1.23
Set if CCOBIX[2:0] != 010 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the global address [22:0] points to an area of the D-Flash EEE partition
Set if the requested section breaches the end of the D-Flash block or goes into
the D-Flash EEE partition
None
Set if any errors have been encountered during the read
Set if any non-correctable errors have been encountered during the read
None
Global address [15:0] of word to be programmed
0x11
Word 1 program value, if desired
Word 2 program value, if desired
Word 3 program value, if desired
CAUTION
Word 0 program value
FCCOB Parameters
Error Condition
Chapter 26 384 KByte Flash Module (S12XFTM384K2V1)
Global address [22:16] to
identify the D-Flash block
Table
26-30)
1007