DEMO9S12XEP100 Freescale Semiconductor, DEMO9S12XEP100 Datasheet - Page 984

• Manufacturer Part Number: DEMO9S12XEP100
• Description: BOARD DEMO FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S12XEP100

• Contents: Board, Cables, CD
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 26 384 KByte Flash Module (S12XFTM384K2V1)
The P-Flash word addressed by ECCRIX = 001 contains the lower 16 bits of the global address. The
following four words addressed by ECCRIX = 010 to 101 contain the 64-bit wide data phrase. The four
data words and the parity byte are the uncorrected data read from the P-Flash block.
The D-Flash word addressed by ECCRIX = 001 contains the lower 16 bits of the global address. The
uncorrected 16-bit data word is addressed by ECCRIX = 010.
26.3.2.14 Flash Option Register (FOPT)
The FOPT register is the Flash option register.
All bits in the FOPT register are readable but are not writable.
During the reset sequence, the FOPT register is loaded from the Flash nonvolatile byte in the Flash
configuration field at global address 0x7F_FF0E located in P-Flash memory (see
by reset condition F in
containing the Flash nonvolatile byte during the reset sequence, all bits in the FOPT register will be set.
26.3.2.15 Flash Reserved0 Register (FRSV0)
This Flash register is reserved for factory testing.
984
GADDR[22:16]
NV[7:0]
Offset Module Base + 0x0010
Reset
PAR[7:0]
XBUS01
Field
7–0
Field
15:8
6–0
W
7
R
Nonvolatile Bits — The NV[7:0] bits are available as nonvolatile bits. Refer to the device user guide for proper
use of the NV bits.
F
7
ECC Parity Bits — Contains the 8 parity bits from the 72 bit wide P-Flash data word or the 6 parity bits,
allocated to PAR[5:0], from the 22 bit wide D-Flash word with PAR[7:6]=00.
Bus Source Identifier — The XBUS01 bit determines whether the ECC error was caused by a read access
from the CPU or XGATE.
0 ECC Error happened on the CPU access
1 ECC Error happened on the XGATE access
Global Address — The GADDR[22:16] field contains the upper seven bits of the global address having
caused the error.
= Unimplemented or Reserved
Figure
F
6
Table 26-28. FECCR Index=000 Bit Descriptions
26-22. If a double bit fault is detected while reading the P-Flash phrase
Figure 26-22. Flash Option Register (FOPT)
MC9S12XE-Family Reference Manual , Rev. 1.23
Table 26-29. FOPT Field Descriptions
F
5
F
4
Description
NV[7:0]
Description
F
3
F
2
Table
Freescale Semiconductor
F
1
26-3) as indicated
F
0