DEMO9S12XEP100 Freescale Semiconductor, DEMO9S12XEP100 Datasheet - Page 506

• Manufacturer Part Number: DEMO9S12XEP100
• Description: BOARD DEMO FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S12XEP100

• Contents: Board, Cables, CD
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Chapter 13 Analog-to-Digital Converter (ADC12B16CV1)
13.1.2
13.1.2.1
There is software programmable selection between performing single or continuous conversion on a
single channel or multiple channels.
13.1.2.2
506
Because of an order from the United States International Trade Commission, BGA-packaged product lines and partnumbers
indicated here currently are not available from Freescale for import or sale in the United States prior to September 2010
•
•
•
Stop Mode
— ICLKSTP=0 (in ATDCTL2 register)
— ICLKSTP=1 (in ATDCTL2 register)
Wait Mode
ADC12B16C behaves same in Run and Wait Mode. For reduced power consumption continuos
conversions should be aborted before entering Wait mode.
Freeze Mode
In Freeze Mode the ADC12B16C will either continue or finish or stop converting according to the
FRZ1 and FRZ0 bits. This is useful for debugging and emulation.
Entering Stop Mode aborts any conversion sequence in progress and if a sequence was aborted
restarts it after exiting stop mode. This has the same effect/consequences as starting a
conversion sequence with write to ATDCTL5. So after exiting from stop mode with a
previously aborted sequence all flags are cleared etc.
A/D conversion sequence seamless continues in Stop Mode based on the internally generated
clock ICLK as ATD clock. For conversions during transition from Run to Stop Mode or vice
versa the result is not written to the results register, no CCF flag is set and no compare is done.
When converting in Stop Mode (ICLKSTP=1) an ATD Stop Recovery time
required to switch back to bus clock based ATDCLK when leaving Stop Mode. Do not access
ATD registers during
Modes of Operation
Conversion Modes
MCU Operating Modes
MC9S12XE-Family Reference Manual , Rev. 1.23
this time
.
Freescale Semiconductor
t
ATDSTPRCV
is