DEMO9S12XEP100 Freescale Semiconductor, DEMO9S12XEP100 Datasheet - Page 973

• Manufacturer Part Number: DEMO9S12XEP100
• Description: BOARD DEMO FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S12XEP100

• Contents: Board, Cables, CD
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

26.3.2.7
The FSTAT register reports the operational status of the Flash module.
1. Reset value can deviate from the value shown if a double bit fault is detected during the reset sequence (see
CCIF, ACCERR, and FPVIOL bits are readable and writable, MGBUSY and MGSTAT bits are readable
but not writable, while remaining bits read 0 and are not writable.
Freescale Semiconductor
ERSVIE1
ERSVIE0
Offset Module Base + 0x0006
DFDIE
Reset
SFDIE
Field
3
2
1
0
W
R
CCIF
EEE Error Type 1 Interrupt Enable — The ERSVIE1 bit controls interrupt generation when a change state error
is detected during an EEE operation.
0 ERSVIF1 interrupt disabled
1 An interrupt will be requested whenever the ERSVIF1 flag is set (see
EEE Error Type 0 Interrupt Enable — The ERSVIE0 bit controls interrupt generation when a sector format error
is detected during an EEE operation.
0 ERSVIF0 interrupt disabled
1 An interrupt will be requested whenever the ERSVIF0 flag is set (see
Double Bit Fault Detect Interrupt Enable — The DFDIE bit controls interrupt generation when a double bit fault
is detected during a Flash block read operation.
0 DFDIF interrupt disabled
1 An interrupt will be requested whenever the DFDIF flag is set (see
Single Bit Fault Detect Interrupt Enable — The SFDIE bit controls interrupt generation when a single bit fault
is detected during a Flash block read operation.
0 SFDIF interrupt disabled whenever the SFDIF flag is set (see
1 An interrupt will be requested whenever the SFDIF flag is set (see
Flash Status Register (FSTAT)
1
7
= Unimplemented or Reserved
Table 26-16. FERCNFG Field Descriptions (continued)
0
0
6
Figure 26-11. Flash Status Register (FSTAT)
MC9S12XE-Family Reference Manual , Rev. 1.23
ACCERR
0
5
FPVIOL
0
4
Description
MGBUSY
Chapter 26 384 KByte Flash Module (S12XFTM384K2V1)
0
3
Section
Section
Section
Section
Section
RSVD
26.3.2.8)
0
2
26.3.2.8)
26.3.2.8)
26.3.2.8)
26.3.2.8)
0
1
(1)
MGSTAT[1:0]
Section
0
0
1
26.6).
973