DEMO9S12XEP100 Freescale Semiconductor, DEMO9S12XEP100 Datasheet - Page 1189

• Manufacturer Part Number: DEMO9S12XEP100
• Description: BOARD DEMO FOR MC9S12XEP100
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S12XEP100

• Contents: Board, Cables, CD
• Processor To Be Evaluated: MC9S12XEP100
• Data Bus Width: 16 bit
• Interface Type: RS-232
• Silicon Manufacturer: Freescale
• Core Architecture: S12
• Core Sub-architecture: S12
• Silicon Core Number: MC9S12
• Silicon Family Name: S12XE
• Rohs Compliant: Yes
• For Use With/related Products: MC9S12XEP100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

29.4.2.14 Set Field Margin Level Command
The Set Field Margin Level command, valid in special modes only, causes the Memory Controller to set
the margin level specified for future read operations of a specific P-Flash or D-Flash block.
Upon clearing CCIF to launch the Set Field Margin Level command, the Memory Controller will set the
field margin level for the targeted block and then set the CCIF flag.
Freescale Semiconductor
FERSTAT
Register
FSTAT
User margin levels can be used to check that Flash memory contents have
adequate margin for normal level read operations. If unexpected results are
encountered when checking Flash memory contents at user margin levels, a
potential loss of information has been detected.
CCOBIX[2:0]
Table 29-60. Set Field Margin Level Command FCCOB Requirements
000
001
MGSTAT1
MGSTAT0
EPVIOLIF
ACCERR
Table 29-59. Set User Margin Level Command Error Handling
Error Bit
FPVIOL
1. Read margin to the erased state
2. Read margin to the programmed state
(CCOBIX=001)
Table 29-58. Valid Set User Margin Level Settings
0x0002
CCOB
MC9S12XE-Family Reference Manual , Rev. 1.23
Set if CCOBIX[2:0] != 001 at command launch
Set if a Load Data Field command sequence is currently active
Set if command not available in current mode (see
Set if an invalid global address [22:16] is supplied
Set if an invalid margin level setting is supplied
None
None
None
None
0x0E
NOTE
User Margin-0 Level
FCCOB Parameters
Margin level setting
Level Description
Global address [22:16] to identify the Flash
Chapter 29 1024 KByte Flash Module (S12XFTM1024K5V2)
Error Condition
(2)
block
Table
29-30)
1189