SAM9XE512 Atmel Corporation, SAM9XE512 Datasheet - Page 283

• Manufacturer Part Number: SAM9XE512
• Manufacturer: Atmel Corporation

Specifications of SAM9XE512

• Flash (kbytes): 512 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 180 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 2
• Uart: 6
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 312
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 1.65 to 1.95
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

ARM DDI 0165B
For Watchpoint 0:
1.
2.
3.
4.
If Watchpoint 0 matches but Watchpoint 1 does not (that is the RANGE input to
Watchpoint 0 is 0), the breakpoint is triggered.
Set the ENABLE bit.
Program the RANGE bit to match a 0.
Program all other Watchpoint 0 registers as normal for a breakpoint.
Program Watchpoint 0 with an address value of
mask of
Copyright © 2000 ARM Limited. All rights reserved.
0X000000FF
.
0x00000000
and an address
Debug in depth
C-43