DF2166VT33WV Renesas Electronics America, DF2166VT33WV Datasheet - Page 726

• Manufacturer Part Number: DF2166VT33WV
• Description: MCU 16BIT FLASH 3V 512K 144-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2166VT33WV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, LPC, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 106
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-TQFP, 144-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

(6)
The boot program will transfer the erasing program, and erase the user MATs and user boot MATs
in that order. On completion of this erasure, ACK will be returned and will enter the
programming/erasing state.
The host should select the device code, clock mode, and new bit rate with device selection, clock-
mode selection, and new bit-rate selection commands, and then send the command for the
transition to programming/erasing state. These procedures should be carried out before sending of
the programming selection command or program data.
Command
• Command, H'40, (1 byte): Transition to programming/erasing state
Response
• Response, H'06, (1 byte): Response to transition to programming/erasing state
Error Response
• Error response, H'C0, (1 byte): Error response for user boot MAT blank check
• Error code, H'51, (1 byte): Erasing error
(7)
A command error will occur when a command is undefined, the order of commands is incorrect,
or a command is unacceptable. Issuing a clock-mode selection command before a device selection
or an inquiry command after the transition to programming/erasing state command, are examples.
Error Response
• Error response, H'80, (1 byte): Command error
• Command, H'xx, (1 byte): Received command
(8)
The order for commands in the inquiry selection state is shown below.
1. A supported device inquiry (H'20) should be made to inquire about the supported devices.
2. The device should be selected from among those described by the returned information and set
3. A clock-mode inquiry (H'21) should be made to inquire about the supported clock modes.
4. The clock mode should be selected from among those described by the returned information
Rev. 3.00, 03/04, page 684 of 830
The boot program will send ACK when the user MAT and user boot MAT have been erased
by the transferred erasing program.
An error occurred and erasure was not completed.
with a device-selection (H'10) command.
and set.
Transition to Programming/Erasing State
Command Error
Command Order
H'40
H'06
H'C0
H'80
H'51
H'xx