DF2166VT33WV Renesas Electronics America, DF2166VT33WV Datasheet - Page 781

• Manufacturer Part Number: DF2166VT33WV
• Description: MCU 16BIT FLASH 3V 512K 144-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2166VT33WV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 33MHz
• Connectivity: I²C, IrDA, LPC, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 106
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 40K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-TQFP, 144-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

23.3
Medium-Speed Mode
The CPU makes a transition to medium-speed mode as soon as the current bus cycle ends
according to the setting of the SCK2 to SCK0 bits in SBYCR. In medium-speed mode, the CPU
operates on the operating clock (φ/2, φ/4, φ/8, φ/16, or φ/32) specified by the SCK2 to SCK0 bits.
The bus masters other than the CPU (DTC) also operate in medium-speed mode when the
DTSPEED bit in SBYCR is cleared to 0. On-chip peripheral modules other than the bus masters
always operate on the system clock (φ).
When the DTSPEED bit in SBYCR or the EXCKS bit in BCR2 is set to 1, the φ clock can be used
as the DTC operating clock or external extended area bus cycle clock.
In medium-speed mode, a bus access is executed in the specified number of states with respect to
the bus master operating clock. For example, if φ/4 is selected as the operating clock, on-chip
memory is accessed in 4 states, and internal I/O registers in 8 states.
By clearing all of bits SCK2 to SCK0 to 0, a transition is made to high-speed mode at the end of
the current bus cycle.
If a SLEEP instruction is executed when the SSBY bit in SBYCR is cleared to 0, and the LSON
bit in LPWRCR is cleared to 0, a transition is made to sleep mode. When sleep mode is cleared by
an interrupt, medium-speed mode is restored. When the SLEEP instruction is executed with the
SSBY bit set to 1, the LSON bit cleared to 0, and the PSS bit in TCSR (WDT_1) cleared to 0,
operation shifts to software standby mode. When software standby mode is cleared by an external
interrupt, medium-speed mode is restored.
When the RES pin is set low, medium-speed mode is cancelled and operation shifts to the reset
state. The same applies in the case of a reset caused by overflow of the watchdog timer.
When the STBY pin is driven low, a transition is made to hardware standby mode.
Figure 23.2 shows an example of medium-speed mode timing.
Rev. 3.00, 03/04, page 739 of 830